It happened in cycle 2 or 3 for the 2 examples !

Is this reproducible when you start another runsp_lapw after

rm *.broy*

-------------

Is it reproducible when using only k-parallel setup, but no mpi ??

------------

Examine case.clmvalup/dn if you see any   NANs in this file.



On 09/22/2016 02:50 PM, Paresh Chandra Rout wrote:
Dear w2k users and developers,

I am facing an error as follows

error: command   WIEN2k_14.2_TGZ/mixer mixer.def   failed

  stop error

I did not encounter this error before. All my calculation was running fine
with this version of wien2k . I tried to run single point calculation on
three
different system, but in all cases I am getting the same error as above
just after the scf cycle-3. I have attached my  case.dayfile for
different system. Any help to resolve this issue would be highly
appreciated .

Kind Regards,
Paresh Chandra Rout
Research Scholar
Indian institute of Science Education and Research Bhopal



_______________________________________________
Wien mailing list
Wien@zeus.theochem.tuwien.ac.at
http://zeus.theochem.tuwien.ac.at/mailman/listinfo/wien
SEARCH the MAILING-LIST at:  
http://www.mail-archive.com/wien@zeus.theochem.tuwien.ac.at/index.html


--

                                      P.Blaha
--------------------------------------------------------------------------
Peter BLAHA, Inst.f. Materials Chemistry, TU Vienna, A-1060 Vienna
Phone: +43-1-58801-165300             FAX: +43-1-58801-165982
Email: bl...@theochem.tuwien.ac.at    WIEN2k: http://www.wien2k.at
WWW:   http://www.imc.tuwien.ac.at/TC_Blaha
--------------------------------------------------------------------------
_______________________________________________
Wien mailing list
Wien@zeus.theochem.tuwien.ac.at
http://zeus.theochem.tuwien.ac.at/mailman/listinfo/wien
SEARCH the MAILING-LIST at:  
http://www.mail-archive.com/wien@zeus.theochem.tuwien.ac.at/index.html

Reply via email to