Hello I manage to connect to YOTA network successfully, and then start dhcp, but after a few minutes connection is lost. It is a reproducible error. I used different dhcp clients: dhclient and dhcpcd. Only dhcpcd outputs error wmx0: carrier lost.
Chip: Intel 6250
Distr - Gentoo x86
Connect to YOTA (step by step):
1) wimaxd -i wmx0 -d
2) wimaxcu ron
3) wimaxcu connect network 21 (Connection successful)
4) dhclient wmx0
5) ping works and ifconfig output:
wmx0 Link encap:Ethernet HWaddr 00:1d:e1:2f:d8:55
inet addr:10.117.31.207 Mask:255.255.248.0
UP RUNNING NOARP MTU:1400 Metric:1
RX packets:2 errors:0 dropped:0 overruns:0 frame:0
TX packets:2 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:20
RX bytes:672 (672.0 B) TX bytes:664 (664.0 B)
6) but after a minute ping does not work and ifconfig output:
wmx0 Link encap:Ethernet HWaddr 00:1d:e1:2f:d8:55
inet addr:10.117.31.207 Mask:255.255.248.0
UP NOARP MTU:1400 Metric:1
RX packets:2112 errors:0 dropped:0 overruns:0 frame:0
TX packets:1851 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:20
RX bytes:8592400 (8.1 MiB) TX bytes:184321 (180.0 KiB)
I tried kernel 2.6.36 and 2.6.37:
config:
-*- Networking support --->
<M> WiMAX Wireless Broadband support --->
<*> RF switch subsystem support --->
Device Drivers --->
[*] Network device support --->
WiMAX Wireless Broadband devices --->
<M> Intel Wireless WiMAX Connection 2400 over USB
<M> Intel Wireless WiMAX Connection 2400 over SDIO
[*] Intel Wireless Multicom WiMAX Connection 3200 over SDIO
(8) WiMAX i2400m debug level
Installed apps (there were no errors during compilation):
1) wimax-1.5.1
2) wimax-tools-1.4.4
3) wpa_supplicant-0.7.3 patched
4) i2400m-fw-1.5.0
I attached logs according to the instructions in FAQ (there are some errors)
I hope for your help.
wimax_logs.tar.bz2
Description: BZip2 compressed data
_______________________________________________ wimax mailing list [email protected] http://lists.linuxwimax.org/listinfo/wimax
