There is still the question about packets loss. According to the essay ' Profiling and Optimization of Software-Based Network-Analysis Applications' , every packet is copied twice in the main memory before reaching the user. In order to reduce the cost of CPU and the bus occupying of the SDRAM of pc, is it possible to copy data directly from the kernel buffer to the final buffer , which I want the date kept in ?
Here is another idea --- allocate several different user buffers , once a user buffer is fulled , then let the next user buffer to save the new datas from kernel buffer. Meanwhile copy datas from the first user buffer to disk (assume that the hard disk write rate is fast enough). Is this idea work with the winpcap ? Thank you! ============================================================== Q1: tough question to answer, as it depends on a number of factors. What is the average packet size? Are you just counting the packets, or dumping them to disk/DB/...? Do you see packet drops in the pcap_stats? Q2: I will need to run some tests on this. Do you have some minimal sample code that shows the issue? Q3: Yes, *if* the NIC (and NIC driver) are not dropping packets themselves. Did you disable any protocol bound to the NIC where you receive all these packets? Have a nice day GV From: yulou liu Sent: Wednesday, August 25, 2010 11:08 AM To: winpcap Subject: [Winpcap-users] About the packets loss , what is the bottleneck ? I'm using winpcap to capture datas from FPGA board via 1G Ethernet connection(directly connected). the FPGA is configed to send data at a special rate. With the fpga sending rate increases,especially above 500Mbps, it sometimes loss packets. Q1: Is it possible to totally avoid packets loss by optimism the code? I want to collect datas at speed 614Mbps without packet loss (collecting all datas last about 1 minutes). My workstations features with 2 Xeon CPU (each has 4core), DDR3 SDRAM, 1 G onboard netcard. Which part is the most probably bottleneck ? Q2: As a test , I found the pcap_next_ex() can't get any packets when the user buffer is set over 64 MB, what does it happen ? Q3: if the Kernel buffer's size is 16MB , then the first 16Mb packets from fpga won't be lost, so , if I set the kernel buffer as 128MB , then at least the first coming 128MB data from FPGA won't be lost either ? but I found When I set the kernel buffer bigger than 100 MB, the packets drops is getting worse. Thanks a lot!
_______________________________________________ Winpcap-users mailing list Winpcap-users@winpcap.org https://www.winpcap.org/mailman/listinfo/winpcap-users
