Hello everyone, I'm having a minor issue with the showconf command: The configuration generated may change over time without any settings changed on the interface, I noticed that peers without an endpoint set suddenly have an endpoint setting in the output once they established a handshake with the remote peer.
Is there a specific reason for this behaviour? If not, then I would argue that showconf should reflect the settings used to configure the interface and not the current state. Having the output of showconf reflect the original configuration in a deterministic way enables configuration/provisioning software to check if the interface is in the desired state and only take action if it's not - that would be very helpful at least to me. Thanks Markus _______________________________________________ WireGuard mailing list WireGuard@lists.zx2c4.com https://lists.zx2c4.com/mailman/listinfo/wireguard