Jeff,
Thanks for the email. I have an email into our DHCP folks to get
them to extend the lease time to 24hrs - it's currently set to 8.
That being said, I looked in our DHCP server log and found that for
an AP that lost its CAPWAP session, right at the time it was lost,
the DHCP log shows 3 DHCP release messages from the AP, then 2
seconds later it shows a DHCP Discover message and then 1 second
later the DHCP Offer, Request, and ACK. So the span of time from
the last DHCP release until DHCP Ack is 3 seconds according to the
DHCP log.
The key here seems to be that the AP, for some reason, felt it had
to release its IP and then go through the entire DHCP process
again. I can understand that throwing the CAPWAP session for a
loop. TAC has said that this is most likely a consequence of some
sort of network disruption, rather than the actual cause.
All that being said, I would think the DHCP snooping database would
show it just being renewed, but I'll check on the next one.
We do not write our database to the local flash or an FTP server.
Thanks,
-dan
Dan Brisson
Network Engineer
University of Vermont
(Ph) 802.656.8111
[email protected]
On 2/6/2012 2:46 PM, Jeffrey Sessler wrote:
Dan,
If you extend the DHCP lease duration of the AP's, and
reenable DAI and IP SV, what happens to the interval between
lost CAPWAP sessions? Perhaps at the DHCP renewal time, DAI and
IP SV introduces enough of a delay to cause a problem with
CAPWAP. With students are gone and the activity with an AP is
low, CAPWAP is OK - but under load/activity - CAPWAP is catching
it.
When an AP does the CAPWAP "dance" what does the lease time
look like in the snooping database? Does it look like it was
just renewed?
Last but not least, are you writing your database to the
local flash of the switch or to a FTP server? Do writes of the
database correspond with the CAPWAP loss? What does the switch
CPU look like at the time i.e. do you have ACL's running that
are pushing work out of the ASICs and on to the CPU?
For those following this thread, while we still
haven't determined the exact cause of this problem, we
also have not had a drop from an AP where we turned off
DAI and IP source verify. Seems logical that one (or
both) of those could be causing problems, although what
is not entirely logical is how that would be related to
load/activity, since the APs never drop when the
students are gone on break.
TAC has been very responsive and at this point I've
asked if we can get someone from the Switching side to
look at the possibility that DAI and/or IP Source verify
could be the cause.
-dan
Dan Brisson
Network Engineer
University of Vermont
(Ph) 802.656.8111
[email protected]
On 2/1/2012 2:38 PM, Dan Brisson wrote:
Ah right, yes, 'mls qos' is NOT configured
on any of the 3560X switches.
We used DAI and DHCP snooping b/c the majority of APs
are actually in student rooms due to, well, no other
place really to put them. :) Now that you've brought
that up, though, we had to go in the ceiling in one of
our newer, bigger complexes. I'm going to turn off
DAI and IP Source verify there and see if the drops
stop.
Will let folks know what I find.
Thanks!
-dan
Dan Brisson
Network Engineer
University of Vermont
(Ph) 802.656.8111
[email protected]
On 2/1/2012 12:41 PM, Garry Peirce wrote:
Dan,
A small but important point
to verify re: QoS.
By ‘no QoS in place’, does
that mean the global ‘mls qos’ is NOT
configured on the resHall switches or that no
specific QoS config has been configured?
Ex. if the global ‘mls qos’
is enabled, all ports (including APs) would be
untrusted by default with all packet markings
remarked as 0.
Also, any QoS/service
policies on the relevant router’s interfaces?
Given the L2 functions you
mention are unique to the ResHall side, I’d
disable them on the ports used by the APs.
I wouldn’t expect these L2
security functions to be needed on known AP
ports and removing them might provide further
insight on the issue.
DAI disabling AP ports due to
ARP pps threshold (odd)? Is errdisable
auto-recovery of DAI enabled?
Any log data from the switch
of an affected AP?
From: The
EDUCAUSE Wireless Issues Constituent Group
Listserv [mailto:[email protected]]
On Behalf Of Dan Brisson
Sent: Wednesday, February 01, 2012
11:35 AM
To: [email protected]
Subject: Re: [WIRELESS-LAN] Cisco
APs losing CAPWAP session
Ok, thanks for validating.
It also seemed a bit strange to me and yes, I
checked a bunch APs that haven't dropped
recently and they all showed 10-12ms.
One thing that occurred to me is we are doing
DHCP snooping and Dynamic Arp Inspection on the
3560Xs. That is unique to this part of campus
as we haven't yet rolled that out to the entire
admin side.
Thanks,
-dan
Dan Brisson
Network Engineer
University of Vermont
(Ph) 802.656.8111
[email protected]
On 2/1/2012 10:23 AM, Mike King wrote:
On Wed, Feb 1, 2012 at
10:03 AM, Dan Brisson <[email protected]>
wrote:
It's been awhile since
I've read these, but If I interpret this
correctly, It took 1m 15s for the AP to
associate to the controller. That's a very
long time. Mine usually have association
in the 10-20 second range.
Not sure what that
indicates, but it's an anomaly from my point
of view.
I don't think it's a
rouge herring. (See Backhoe joke from
earlier in the thread)
********** Participation and
subscription information for this EDUCAUSE
Constituent Group discussion list can be found
at http://www.educause.edu/groups/.
********** Participation and
subscription information for this EDUCAUSE
Constituent Group discussion list can be found
at http://www.educause.edu/groups/.
********** Participation and subscription
information for this EDUCAUSE Constituent Group
discussion list can be found at http://www.educause.edu/groups/.
********** Participation and subscription information
for this EDUCAUSE Constituent Group discussion list
can be found at http://www.educause.edu/groups/.
|
********** Participation and subscription information for this
EDUCAUSE Constituent Group discussion list can be found at
http://www.educause.edu/groups/.
**********
Participation and subscription information for this EDUCAUSE Constituent Group discussion list can be found at http://www.educause.edu/groups/.
|