Now i've just tried to but a BR350 in the place of AP350. All config defaults. The problem i had with AP350 happened exactly equal on the BR350 (i tried it in Bridge Root and Access Point Root mode).
So, the only way, is to have WGB352 ? At 10:30 27/9/2002 -0700, Moebius wrote: >You are not doing anything wrong.. It is cisco trying to force you to >buy BR350's or WGB352's for wireless bridging.. > >In my wireless network I tried using LINKSYS WAP11's on the customer >side as a bridge.. I had limited success if I set the MAC address of the >WAP11 and the NAT device attached to the WAP11 to the same address.. and >set the IP address of the WAP11 and NAT device to the same thing.. This >seemed to fool the Cisco into thinking it was a single device and worked >ok.. > >But as soon as more than one MAC address shows up for a single "client" >connection, you are hosed.. > >The only dependable way I have found to do it is via WGB352's and >BR350's.. I have not tried some of the linux implementations of clients >with NAT built in.. these may fit the bill.. > > > >-----Original Message----- >From: [EMAIL PROTECTED] >[mailto:[EMAIL PROTECTED]] On Behalf Of Ulisses >Sent: Friday, September 27, 2002 9:50 AM >To: [EMAIL PROTECTED] >Subject: [BAWUG] AP350 Problem > > >Hi, > >I have a AP350 (that with external antennas) and i'm having some >dificulties with it. > >It is with FirmWare 11.23T. It is the only unit acting as AP in my net. >It >is with ALL the default factory config, except SSID, and IP. > >I CAN associate and use it with any PCCARD and PCI (i've tested PCMCIA >Cisco 340, PCMCIA Cisco 350, PCI350, Linksys PCI, D-Link PCI, etc). > >But when i try to use a cheap AP (i've tried D-Link DWL-900AP+ and >LinkSYS >WAP11) in "AP Client" mode, i get some strange results. > >The "AP Client" associate with AP350, and from AP350 (and any client >conected to AP350) i can ping the "AP Client". > >BUT when i try to ping AP350 (or any client connected to AP350) from a >PC >conected to the ethernet port of the "AP Client", it doesn't work. > >And i got a lot of "Disassociating 'AP Client', reason Not Associated" >in >the AP350 console. > > >What i'm oing wrong ? > >Thank You, >Ulisses > >-- >general wireless list, a bawug thing <http://www.bawug.org/> >[un]subscribe: http://lists.bawug.org/mailman/listinfo/wireless -- general wireless list, a bawug thing <http://www.bawug.org/> [un]subscribe: http://lists.bawug.org/mailman/listinfo/wireless
