At absolute total effort, conserve and be respectful to 900Mhz spectrum.
900 is very unique spectrum in demand, with little available. Interference
can be picked up from 30 miles away easilly.
There are also many 900 uses that use jsut small slices here and there. And
there are many things that can kill the upper channels.
The best policy is to use the minimum you need, so that you leave room for
others not to interfer with you. The others that use 900, often use it for
less critical applications and they'll deploy with little remorse or
knowledge that you are fighting on the same channels with interference. I'd
rarely use over 6mhz channels, unless you live in a desolate jungle, with no
one to interfere with, and lots of hills to block your signal from going to
far out.
If you absolutely must use 900 to get around obstructuions and absolutely
need the higher capacity, then to get a wider channel size, use directional
Yagis, and cavity filters to clean up the high and low end, if needed to
minimize interference.
Tom DeReggi
RapidDSL & Wireless, Inc
IntAirNet- Fixed Wireless Broadband
----- Original Message -----
From: "Jim Stout" <[EMAIL PROTECTED]>
To: "WISPA General List" <wireless@wispa.org>
Sent: Sunday, April 08, 2007 10:14 AM
Subject: [WISPA] 900 MHz Help
Folks,
I'm just entering into the 900MHz space and would appreciate any advice
on channel selection and channel width settings.
TIA, Jim....
Jim Stout
LTO Communications, LLC
15701 Henry Andrews Dr
Pleasant Hill, MO 64080
(816) 305-1076 - Mobile
(816) 497-0033 - Pager
--
WISPA Wireless List: wireless@wispa.org
Subscribe/Unsubscribe:
http://lists.wispa.org/mailman/listinfo/wireless
Archives: http://lists.wispa.org/pipermail/wireless/
--
WISPA Wireless List: wireless@wispa.org
Subscribe/Unsubscribe:
http://lists.wispa.org/mailman/listinfo/wireless
Archives: http://lists.wispa.org/pipermail/wireless/
