Chuck, Give me a call off line, We operate on 5 of the largest Windmill farms in the nation....... I'll tell you all you need to know.... and things you don't want to know....lol
Chuck Moses HIGH DESERT WIRELESS BROADBAND COMMUNICATION 16922 Airport Blvd # 17 Mojave CA 93501 661 824 3431 office 818 406 6818 cell -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of [EMAIL PROTECTED] Sent: Thursday, May 03, 2007 3:09 PM To: WISPA General List Subject: Re: [WISPA] Tilting at Windmills Because these aren't built yet, the image in my mind is for us to stick up above the blades...meaning the windmill tower itself would be higher than it normally would be, or we'd add an extension to make it so. Well, maybe that's an unrealistic daydream. Chuck At 12:59 PM -0700 5/3/07, [EMAIL PROTECTED] wrote: >if the blades are composite or fiberglass you may get through, but the receive >jitter will probably drive the radio card nuts. If there is enough room under >the blades to see what you want to see it should be great. A piece of foam on >your board and lil rubber on antenna mounts should give you all the vibration >dampening you will need. Don't forget to reground the antenna with a wire. >There may be an unused tower too. Also over here there are standard 25g's >scattered around to transmit the controller information. Good Luck >Chuck Profito >CV-Access, Inc >209-988-7388 > >Quoting Mike Hammett <[EMAIL PROTECTED]>: > >> I would think there would be an issue with the gigantic spinning pieces of >> metal. >> >> >> ----- >> Mike Hammett >> Intelligent Computing Solutions >> http://www.ics-il.com >> >> >> ----- Original Message ----- >> From: <[EMAIL PROTECTED]> >> To: "WISPA General List" <wireless@wispa.org> >> Sent: Thursday, May 03, 2007 1:52 PM >> Subject: [WISPA] Tilting at Windmills >> >> >> > I've got a township in PA that is eager to have us expand to their area, >> > which is typically quite hilly. They're asking me if we could mount on >> > wind mills, which they are apparently already encouraging. >> > >> > Anyone have any experience with this? I can imagine problems (like >> > vibration), but my imagination often runs wild... >> > >> > Thanks! >> > >> > Chuck >> > -- >> > ----------------------- >> > Chuck Bartosch >> > Clarity Connect, Inc. >> > 200 Pleasant Grove Road >> > Ithaca, NY 14850 >> > (607) 257-8268 >> > >> > If at first you do succeed, try not to look astonished. >> > >> > -- >> > WISPA Wireless List: wireless@wispa.org >> > >> > Subscribe/Unsubscribe: >> > http://lists.wispa.org/mailman/listinfo/wireless >> > >> > Archives: http://lists.wispa.org/pipermail/wireless/ >> > >> >> -- >> WISPA Wireless List: wireless@wispa.org >> >> Subscribe/Unsubscribe: >> http://lists.wispa.org/mailman/listinfo/wireless >> >> Archives: http://lists.wispa.org/pipermail/wireless/ >> > > > >-- >WISPA Wireless List: wireless@wispa.org > >Subscribe/Unsubscribe: >http://lists.wispa.org/mailman/listinfo/wireless > >Archives: http://lists.wispa.org/pipermail/wireless/ -- ----------------------- Chuck Bartosch Clarity Connect, Inc. 200 Pleasant Grove Road Ithaca, NY 14850 (607) 257-8268 If at first you do succeed, try not to look astonished. -- WISPA Wireless List: wireless@wispa.org Subscribe/Unsubscribe: http://lists.wispa.org/mailman/listinfo/wireless Archives: http://lists.wispa.org/pipermail/wireless/ -- WISPA Wireless List: wireless@wispa.org Subscribe/Unsubscribe: http://lists.wispa.org/mailman/listinfo/wireless Archives: http://lists.wispa.org/pipermail/wireless/
