Client is a CPQ-19, 200mw/19db It is mounted on a 45 foot mast. If it was obstructions would I not see it at the client end as well? I was kinda thinking #4, I need to go through all of the clients to compare the different signals.
Mark McElvy -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Jack Unger Sent: Friday, May 18, 2007 12:22 PM To: WISPA General List Subject: Re: [WISPA] Signal opinions Mark, For starters, this can be due to: 1. Lower transmit power on CPE radio compared to AP radio (the CPE transmitter may be bad or the CPE may just have a lower rated power output than the AP transmitter) 2. Too-low CPE antenna gain (use as high a gain as the FCC and the homeowner and the antenna mounting facilities allow) 3. Obstructions at or near the CPE end (you may need to raise the antenna higher) 4. Low sensitivity on AP receiver (does this disparity happen on all clients or on just one client?) jack Mark McElvy wrote: > I run Mikrotik AP's, 15db 120 sectors, WLM54G radios, running Tranzeo > CPQ radios. I have noticed on one sector specifically but not positive > about the others, that the CPQ can see the AP with a -75 and the AP will > see the client a -90. I don't understand the disparity between the > radios. > > > > Mark McElvy > > > > > -- Jack Unger ([EMAIL PROTECTED]) - President, Ask-Wi.Com, Inc. FCC License # PG-12-25133 Serving the Broadband Wireless Industry Since 1993 Author of the WISP Handbook - "Deploying License-Free Wireless WANs" True Vendor-Neutral Wireless Consulting-Training-Troubleshooting FCC Part 15 Certification for Manufacturers and Service Providers Phone (VoIP Over Broadband Wireless) 818-227-4220 www.ask-wi.com -- WISPA Wireless List: [email protected] Subscribe/Unsubscribe: http://lists.wispa.org/mailman/listinfo/wireless Archives: http://lists.wispa.org/pipermail/wireless/ -- WISPA Wireless List: [email protected] Subscribe/Unsubscribe: http://lists.wispa.org/mailman/listinfo/wireless Archives: http://lists.wispa.org/pipermail/wireless/
