I'd use redline an80 On Thu, Mar 5, 2009 at 8:35 AM, Adam Greene <[email protected]> wrote:
> You might look into the Radwin RW-2000 ... speeds and price may be in the > range ... 5.x GHz > > ----- Original Message ----- > From: Travis Johnson > To: WISPA General List > Sent: Thursday, March 05, 2009 12:12 AM > Subject: Re: [WISPA] Short 100Meg full duplex hop needed > > > The Mikrotik solution can be done... but you will need a lot of clean > spectrum to make it happen. At only a mile, you could use an RB433AH with a > couple SR5 cards on each side. There is even an integrated antenna that will > hold all of this, and provide vertical and horizontal antennas in the same > enclosure ( > http://www.titanwirelessonline.com/ProductDetails.asp?ProductCode=AT-19DP-58-R2 > ) > > 2 x RB433AH > 4 x SR5 cards > 2 x dual pol antenna enclosures with pigtails > > I would estimate total cost of parts to be less than $800. A couple hours > to build, test and configure and you should be good to go. The only real > challenge will be finding two open 40mhz wide channels. However, I would > think that could be done in the 5.3ghz and 5.4ghz bands without a problem. > > Travis > Microserv > > Ryan Ghering wrote: > ok after talking with the client they have informed me that they only NEED > 40 to 50 meg full duplex. > and they are very price conscious as well. I was informed late today that I > get the bid for this project if > I can do it for under 5 grand. So with labor and a small bit of profit, I'm > not sure I can make it happen > do the unlicensed products like microtik or staros meet these specs. I see > that microtik has a unit they say can do > 60 to 80 meg. but whats the real bandwidth like and does anyone have > experiance with them? > > Ryan > > On Wed, Mar 4, 2009 at 8:43 PM, RickG <[email protected]> wrote: > > Why would you go unlicensed if you can go licensed for slightly more? > -RickG > > On Wed, Mar 4, 2009 at 5:34 PM, 3-dB Networks <[email protected]> wrote: > > An unlicensed Dragonwave 24GHz link will get you there slightly > cheaper... > PtP600 is the only unlicensed radio that I know of that could do it... > but > that's going to be more expensive than the Dragonwave hop. > > Daniel White > 3-dB Networks > http://www.3dbnetworks.com > > > -----Original Message----- > From: [email protected] [mailto:[email protected]] On > Behalf Of Travis Johnson > Sent: Wednesday, March 04, 2009 2:47 PM > To: WISPA General List > Subject: Re: [WISPA] Short 100Meg full duplex hop needed > > The most cost effective solution is going to be licensed. At $11,000 for > a complete link, that's probably the cheapest thing you are going to > find for this kind of bandwidth. > > Travis > Microserv > > Ryan Ghering wrote: > I'm in need run a link 100 meg full duplex at 1 mile. Unlicensed > gear > is > preferred as this is a low budget hop. > Any recommendations for this? Anything like microtik that has this > capacity? > Thanks > Ryan > > > ---------------------------------------------------------------------- > ---------- > WISPA Wants You! Join today! > http://signup.wispa.org/ > ---------------------------------------------------------------------- > ---------- > WISPA Wireless List: [email protected] > > Subscribe/Unsubscribe: > http://lists.wispa.org/mailman/listinfo/wireless > > Archives: http://lists.wispa.org/pipermail/wireless/ > > > > > ------------------------------------------------------------------------ > -------- > WISPA Wants You! Join today! > http://signup.wispa.org/ > ------------------------------------------------------------------------ > -------- > > WISPA Wireless List: [email protected] > > Subscribe/Unsubscribe: > http://lists.wispa.org/mailman/listinfo/wireless > > Archives: http://lists.wispa.org/pipermail/wireless/ > > > > > > -------------------------------------------------------------------------------- > WISPA Wants You! Join today! > http://signup.wispa.org/ > > > > > -------------------------------------------------------------------------------- > WISPA Wireless List: [email protected] > > Subscribe/Unsubscribe: > http://lists.wispa.org/mailman/listinfo/wireless > > Archives: http://lists.wispa.org/pipermail/wireless/ > > > > -------------------------------------------------------------------------------- > WISPA Wants You! Join today! > http://signup.wispa.org/ > > > -------------------------------------------------------------------------------- > > WISPA Wireless List: [email protected] > > Subscribe/Unsubscribe: > http://lists.wispa.org/mailman/listinfo/wireless > > Archives: http://lists.wispa.org/pipermail/wireless/ > > > > > -------------------------------------------------------------------------------- > WISPA Wants You! Join today! > http://signup.wispa.org/ > > -------------------------------------------------------------------------------- > > WISPA Wireless List: [email protected] > > Subscribe/Unsubscribe: > http://lists.wispa.org/mailman/listinfo/wireless > > Archives: http://lists.wispa.org/pipermail/wireless/ > > > > > > ------------------------------------------------------------------------------ > > > > > > > -------------------------------------------------------------------------------- > WISPA Wants You! Join today! > http://signup.wispa.org/ > > > -------------------------------------------------------------------------------- > > WISPA Wireless List: [email protected] > > Subscribe/Unsubscribe: > http://lists.wispa.org/mailman/listinfo/wireless > > Archives: http://lists.wispa.org/pipermail/wireless/ > > > > -------------------------------------------------------------------------------- > WISPA Wants You! Join today! > http://signup.wispa.org/ > > -------------------------------------------------------------------------------- > > WISPA Wireless List: [email protected] > > Subscribe/Unsubscribe: > http://lists.wispa.org/mailman/listinfo/wireless > > Archives: http://lists.wispa.org/pipermail/wireless/ > -- John M. McDowell Boonlink Communications 307 Grand Ave NW Fort Payne, AL 35967 256.844.9932 [email protected] www.boonlink.com This message contains information which may be confidential and privileged. Unless you are the addressee (or authorized to receive for the addressee), you may not use, copy, re-transmit, or disclose to anyone the message or any information contained in the message. If you have received the message in error, please advise the sender by reply e-mail [email protected], and delete the message. E-mail communication is highly susceptible to spoofing, spamming, and other tampering, some of which may be harmful to your computer. If you are concerned about the authenticity of the message or the source, please contact the sender directly. -------------------------------------------------------------------------------- WISPA Wants You! Join today! http://signup.wispa.org/ -------------------------------------------------------------------------------- WISPA Wireless List: [email protected] Subscribe/Unsubscribe: http://lists.wispa.org/mailman/listinfo/wireless Archives: http://lists.wispa.org/pipermail/wireless/
