Question on this...

If you simply make the MT bridge the traffic, leaving VLAN tags alone,
could torch see the traffic?

On 6/13/09, Butch Evans <[email protected]> wrote:
> On Sat, 2009-06-13 at 09:01 -0400, Adam Greene wrote:
>> A while back we experimented with trunking VLANs over a Mikrotik backhaul,
>>
>> and *at the same time* putting the Mikrotiks themselves into a tagged
>> 802.1q
>> management VLAN. We had major problems with that.
>
> I just did this the other day. There are several possible scenarios that
> you can do:
>
> 1. Straight passing of vlan tags (just simple layer2 bridge) where the
> MT is not "participating" in any of the vlans.  This is very easy, as
> you said.
>
> 2. Passthrough of tagged traffic and the MT participates in one or more
> vlans (management vlan for example).  This, too, is fairly easy.
>       * Build the bridge to include the ports that will passthrough
>         traffic.
>       * Build a bridge to "host" the management vlan.
>       * Create a vlan on the passthrough bridge and add this vlan
>         interface to the "vlan host" bridge.  DO NOT add the
>           management vlan as a port on the "passthrough bridge"
>       * managment IP address would be assigned to the "vlan host"
>           bridge
> 3. VLAN termination with trunked port.  Simply add vlan interfaces on
> the physical interface.  IP addresses for each vlan would be assigned to
> the vlan interfaces themselves.  The physical interface would then be
> equivalent to a Cisco "trunk" port.  Each vlan is a "routing interface"
> in this scenario.
>
> 4. VLAN participation where multiple ports participate in the vlan.
> This is a bit more complex type of configuration and describing steps to
> create this would be too difficult to do here in a "generic" fasion.
>
> You can, of course, have combinations of all the above.  The "trick"
> with Mikrotik is a matter of creative use of bridges and vlans and
> understanding traffic flow at layer 2.
>
> --
> ********************************************************************
> * Butch Evans                   * Professional Network Consultation*
> * http://www.butchevans.com/    * Network Engineering              *
> * http://www.wispa.org/         * WISPA Board Member               *
> * http://blog.butchevans.com/   * Wired or Wireless Networks       *
> ********************************************************************
>
>
>
>
> --------------------------------------------------------------------------------
> WISPA Wants You! Join today!
> http://signup.wispa.org/
> --------------------------------------------------------------------------------
>
> WISPA Wireless List: [email protected]
>
> Subscribe/Unsubscribe:
> http://lists.wispa.org/mailman/listinfo/wireless
>
> Archives: http://lists.wispa.org/pipermail/wireless/
>


-- 
Josh Luthman
Office: 937-552-2340
Direct: 937-552-2343
1100 Wayne St
Suite 1337
Troy, OH 45373

"When you have eliminated the impossible, that which remains, however
improbable, must be the truth."
--- Sir Arthur Conan Doyle


--------------------------------------------------------------------------------
WISPA Wants You! Join today!
http://signup.wispa.org/
--------------------------------------------------------------------------------
 
WISPA Wireless List: [email protected]

Subscribe/Unsubscribe:
http://lists.wispa.org/mailman/listinfo/wireless

Archives: http://lists.wispa.org/pipermail/wireless/

Reply via email to