Well the config interface is very clear about which model it is, also it would be on the unit and the box.
Regards Michael Baird > No idea. > > ----- Original Message ----- > From: "Michael Baird" <[email protected]> > To: "WISPA General List" <[email protected]> > Sent: Thursday, November 12, 2009 7:40 AM > Subject: Re: [WISPA] ubiquity bullet2 > > > >> Marlon, >> >> I thought about this after you mentioned it, we are using Ubiquity on >> the tower also, not MT, vendor readings will vary. >> >> Are you using Bullet2HP's or Bullet2M's? The M series isn't wholly G >> compatible at this time. >> >> Regards >> Michael Baird >> >>> It's an omni... >>> >>> I think I'm gonna pull this out and drop in a tranzeo to see what it does >>> as >>> well. >>> marlon >>> >>> ----- Original Message ----- >>> From: "Michael Baird" <[email protected]> >>> To: "WISPA General List" <[email protected]> >>> Sent: Wednesday, November 11, 2009 8:38 AM >>> Subject: Re: [WISPA] ubiquity bullet2 >>> >>> >>> >>> >>>> Marlon, >>>> >>>> We've had quite a few deployed (100 or so, some for 6 months), not seen >>>> a week transmitter yet, all failures were ethernet related and normally >>>> out of the box they failed (1 in the field). The levels are normally >>>> within 1/2 db at the tower vs. the CPE, unless there is a tilt issue (AP >>>> antenna too much downtilt). >>>> >>>> Regards >>>> Michael Baird >>>> >>>> >>>>> Hi All, >>>>> >>>>> I tried my first one of these yesterday. It's hooked to an antenna >>>>> that >>>>> was >>>>> already in place so I know the old system worked though I did not check >>>>> signal levels before taking out the old SB radios (they don't give rssi >>>>> accurately anyway so there was no point). >>>>> >>>>> This new radio has an RSSI of -78 or so coming FROM the tower. AT the >>>>> tower >>>>> we're picking up -88 or so. I turned it up to 20dB out (factory was >>>>> set >>>>> at >>>>> 16) and that did help a bit. >>>>> >>>>> The calculations show that I should be in the -74 to -78 range based on >>>>> the >>>>> exact distance of the link. So my RSSI AT the remote end is right in >>>>> there. >>>>> I should be seeing the same at the tower as well. >>>>> >>>>> Anyone seen these units have faulty transmitters? This is the third >>>>> ubiquity I've tried. Two PowerStations died (receive sensitivity went >>>>> dead) >>>>> after several months. Both units at almost the exact same time. This >>>>> not >>>>> giving me any comfort levels at all.... >>>>> >>>>> I know others out there are using a lot of these, are you seeing ANY >>>>> strange >>>>> issues at all? Have you looked at the RSSI from both ends? Does it >>>>> match? >>>>> >>>>> Thanks, >>>>> marlon >>>>> >>>>> >>>>> >>>>> -------------------------------------------------------------------------------- >>>>> WISPA Wants You! Join today! >>>>> http://signup.wispa.org/ >>>>> -------------------------------------------------------------------------------- >>>>> >>>>> WISPA Wireless List: [email protected] >>>>> >>>>> Subscribe/Unsubscribe: >>>>> http://lists.wispa.org/mailman/listinfo/wireless >>>>> >>>>> Archives: http://lists.wispa.org/pipermail/wireless/ >>>>> >>>>> >>>>> >>>> -------------------------------------------------------------------------------- >>>> WISPA Wants You! Join today! >>>> http://signup.wispa.org/ >>>> -------------------------------------------------------------------------------- >>>> >>>> WISPA Wireless List: [email protected] >>>> >>>> Subscribe/Unsubscribe: >>>> http://lists.wispa.org/mailman/listinfo/wireless >>>> >>>> Archives: http://lists.wispa.org/pipermail/wireless/ >>>> >>>> >>> >>> -------------------------------------------------------------------------------- >>> WISPA Wants You! Join today! >>> http://signup.wispa.org/ >>> -------------------------------------------------------------------------------- >>> >>> WISPA Wireless List: [email protected] >>> >>> Subscribe/Unsubscribe: >>> http://lists.wispa.org/mailman/listinfo/wireless >>> >>> Archives: http://lists.wispa.org/pipermail/wireless/ >>> >>> >> >> -------------------------------------------------------------------------------- >> WISPA Wants You! Join today! >> http://signup.wispa.org/ >> -------------------------------------------------------------------------------- >> >> WISPA Wireless List: [email protected] >> >> Subscribe/Unsubscribe: >> http://lists.wispa.org/mailman/listinfo/wireless >> >> Archives: http://lists.wispa.org/pipermail/wireless/ >> > > > > -------------------------------------------------------------------------------- > WISPA Wants You! Join today! > http://signup.wispa.org/ > -------------------------------------------------------------------------------- > > WISPA Wireless List: [email protected] > > Subscribe/Unsubscribe: > http://lists.wispa.org/mailman/listinfo/wireless > > Archives: http://lists.wispa.org/pipermail/wireless/ > -------------------------------------------------------------------------------- WISPA Wants You! Join today! http://signup.wispa.org/ -------------------------------------------------------------------------------- WISPA Wireless List: [email protected] Subscribe/Unsubscribe: http://lists.wispa.org/mailman/listinfo/wireless Archives: http://lists.wispa.org/pipermail/wireless/
