I have tools from Tessco. I love the EZ connectors. Good positive snap when seated properly. I use a hacksaw to cut the cable. No smashing and with a little care a right angle cut is not hard. The saw does require some deburring. I use the tool, but a file will work. The one think you don't have listed is a pair of scissors. Makes trimming the braid much easier.
You need an ST-600EZ for the LMR600. The tooling for 400 and 600 are different. D. Ryan Spott wrote: > I am looking for the following: > EZ-400-NMH-D Connector > CCT-01 Tool (cutter) > ST-400EZ tool (cable Prep tool) > DBT-U (deburr tool) > HX4 Tool (crimp tool) > > Separately or in a kit... > > Does anyone have a favorite Vendor? I saw one vendor selling a kit for > LMR400/600 with all of the above parts. They wanted over $1000 for it! > > The 'EZ-Crimp" connectors look like the way to go, but other advice is > appreciated. > > ryan > > > -------------------------------------------------------------------------------- > WISPA Wants You! Join today! > http://signup.wispa.org/ > -------------------------------------------------------------------------------- > > WISPA Wireless List: [email protected] > > Subscribe/Unsubscribe: > http://lists.wispa.org/mailman/listinfo/wireless > > Archives: http://lists.wispa.org/pipermail/wireless/ > > > -- Scott Reed Sr. Systems Engineer GAB Midwest 1-800-363-1544 x2241 1-260-827-2241 Cell: 260-273-7239 -------------------------------------------------------------------------------- WISPA Wants You! Join today! http://signup.wispa.org/ -------------------------------------------------------------------------------- WISPA Wireless List: [email protected] Subscribe/Unsubscribe: http://lists.wispa.org/mailman/listinfo/wireless Archives: http://lists.wispa.org/pipermail/wireless/
