I've tried manipulating it but no help either. I've been leaving the
AP on automatic and manually adjusting the far end.

On Thu, Aug 5, 2010 at 7:39 PM, Mark Nash - Lists <[email protected]> wrote:
> Did ack timing get off somehow?
>
> ----- Original Message -----
> From: "KosiNet Wireless" <[email protected]>
> To: "WISPA General List" <[email protected]>
> Sent: Thursday, August 05, 2010 4:33 PM
> Subject: Re: [WISPA] Ubiquiti Link - Poor Performance
>
>
>> Rick,
>>
>> I hate to ask what my be obvious.... Are you running through a switch?
>> Could
>> it be a negotiation issue?
>>
>> But, with the signal degradation, it sounds more like an antenna or water
>> issue.
>>
>> -Gary-
>>
>> ----- Original Message -----
>> From: "RickG" <[email protected]>
>> To: <[email protected]>; "WISPA General List" <[email protected]>
>> Sent: Thursday, August 05, 2010 5:30 PM
>> Subject: Re: [WISPA] Ubiquiti Link - Poor Performance
>>
>>
>> Faisal, I was hoping you would reply! My answers inline below:
>>
>> On Thu, Aug 5, 2010 at 4:30 PM, Faisal Imtiaz <[email protected]>
>> wrote:
>>> do the ususal stuff...
>>>
>>> Try changing channel ?
>>
>> Yes. Tried all available channels.
>>
>>> Try to shrink the channel to 10mhz or 5mhz
>>
>> Yes. Results were just as bad if not worse.
>>
>>>
>>> Any possibility of water in the cables  ?
>> or something phyiscally off
>>> with the coax jumpers ?
>>
>> I tried multiple new cables. Plus, eliminated cables by using the
>> Nanobridge.
>>
>>>(AP side ?)
>>>
>>> Since you have done everything on the far side. how about looking at the
>>> AP Side....
>>
>> It's possible. Going there now. But, other link off sector is working
>> well albeit a bit degraded compared to what it was when originally
>> installed.
>>
>>>
>>>
>>> Run ...Airview to see if there is interference that is not being picked
>>> up on site survey ?
>>
>> Airview channel usage attached. I didnt realize you have to save each
>> scan separately. WIll get all results later.
>>
>>>
>>> Faisal Imtiaz
>>> Snappy Internet& Telecom
>>>
>>> On 8/5/2010 4:01 PM, RickG wrote:
>>>> Here is a good one!
>>>>
>>>> I have a short "link" of about 3 miles from my main tower to another.
>>>> On the main tower I have four UBNT 5G-20-90's with RockeyM5's running
>>>> firmware 5.2. All have performed very well since I installed them
>>>> earlier this year. On the other end at the problem tower I have a 26Db
>>>> grid with a BulletM5 also running fw5.2. The link was doing well until
>>>> two days ago. Then, the latency went through the roof. I assumed it
>>>> was the radio but after switching it out twice, I decided to blame the
>>>> antenna. So, I swapped out the grids multiple times. Then decided to
>>>> try a Nanostation, and a Nanobridge but got worse results. I'd blame
>>>> the sector on the main tower but another link on it remains working
>>>> well. There is a topology difference between the working link and the
>>>> poor link with the later being higher. There is some noise in the area
>>>> but not unusual. What I do note is that the main tower does not "see"
>>>> the far end very well (-78) and it should really be much higher. The
>>>> receive rate is only 6.5Mbps.
>>>>
>>>> At any rate, I've got about 3 dozen subs on this tower and worked on
>>>> it until 5am so I'm ready for some fresh input!
>>>>
>>>> Thanks in advance!
>>>> -RickG
>>>>
>>>>
>>>> --------------------------------------------------------------------------------
>>>> WISPA Wants You! Join today!
>>>> http://signup.wispa.org/
>>>> --------------------------------------------------------------------------------
>>>>
>>>> WISPA Wireless List: [email protected]
>>>>
>>>> Subscribe/Unsubscribe:
>>>> http://lists.wispa.org/mailman/listinfo/wireless
>>>>
>>>> Archives: http://lists.wispa.org/pipermail/wireless/
>>>>
>>>>
>>>
>>>
>>> --------------------------------------------------------------------------------
>>> WISPA Wants You! Join today!
>>> http://signup.wispa.org/
>>> --------------------------------------------------------------------------------
>>>
>>> WISPA Wireless List: [email protected]
>>>
>>> Subscribe/Unsubscribe:
>>> http://lists.wispa.org/mailman/listinfo/wireless
>>>
>>> Archives: http://lists.wispa.org/pipermail/wireless/
>>>
>>
>>
>>
>> --------------------------------------------------------------------------------
>>
>>
>>>
>>>
>>> --------------------------------------------------------------------------------
>>> WISPA Wants You! Join today!
>>> http://signup.wispa.org/
>>> --------------------------------------------------------------------------------
>>>
>>> WISPA Wireless List: [email protected]
>>>
>>> Subscribe/Unsubscribe:
>>> http://lists.wispa.org/mailman/listinfo/wireless
>>>
>>> Archives: http://lists.wispa.org/pipermail/wireless/
>>
>>
>>
>> --------------------------------------------------------------------------------
>> WISPA Wants You! Join today!
>> http://signup.wispa.org/
>> --------------------------------------------------------------------------------
>>
>> WISPA Wireless List: [email protected]
>>
>> Subscribe/Unsubscribe:
>> http://lists.wispa.org/mailman/listinfo/wireless
>>
>> Archives: http://lists.wispa.org/pipermail/wireless/
>>
>
>
>
>
> --------------------------------------------------------------------------------
> WISPA Wants You! Join today!
> http://signup.wispa.org/
> --------------------------------------------------------------------------------
>
> WISPA Wireless List: [email protected]
>
> Subscribe/Unsubscribe:
> http://lists.wispa.org/mailman/listinfo/wireless
>
> Archives: http://lists.wispa.org/pipermail/wireless/
>


--------------------------------------------------------------------------------
WISPA Wants You! Join today!
http://signup.wispa.org/
--------------------------------------------------------------------------------
 
WISPA Wireless List: [email protected]

Subscribe/Unsubscribe:
http://lists.wispa.org/mailman/listinfo/wireless

Archives: http://lists.wispa.org/pipermail/wireless/

Reply via email to