That's likely it. -62 is an awfully hot signal too. I try to stay between -65 and -75. Usually it's closer to -75 or -80 these days though.
With the 1 meg (handshakes etc.) speed sensitivity of the radios nowadays at -94 or better that 30dB knife edge reflection off metal is much more common of a problem than it used to be. Might also just try turning the power down on the unit. Move it up, down or sideways, sometimes by just a couple of feet. Hope that helps, marlon ----- Original Message ----- From: "Jeremie Chism" <[email protected]> To: "WISPA General List" <[email protected]> Sent: Wednesday, September 08, 2010 12:36 PM Subject: [WISPA] Wireless errors >I have a wireless sub that from everything I can tell has a very good link. >The signal is -62. Line of sight. No fade etc etc. There is only one >problem. I am seeing fec errors. I just checked and the installer put it to >where there is a power line about 25-30 feet straight out in front of the >cpe. Could this cause the errors? > > Sent from my iPhone > > > -------------------------------------------------------------------------------- > WISPA Wants You! Join today! > http://signup.wispa.org/ > -------------------------------------------------------------------------------- > > WISPA Wireless List: [email protected] > > Subscribe/Unsubscribe: > http://lists.wispa.org/mailman/listinfo/wireless > > Archives: http://lists.wispa.org/pipermail/wireless/ -------------------------------------------------------------------------------- WISPA Wants You! Join today! http://signup.wispa.org/ -------------------------------------------------------------------------------- WISPA Wireless List: [email protected] Subscribe/Unsubscribe: http://lists.wispa.org/mailman/listinfo/wireless Archives: http://lists.wispa.org/pipermail/wireless/
