I just put up a couple of new towers with MT/XR9 based APs. When they went up about 3 weeks ago, everything was good. Signals were good. Noise level in the 90s. Customers worked well. Yesterday we were at a customer that has been problematic for 2 weeks or so. Connected to the radio with power from the truck and the network was great. Didn't really look at noise levels, but signals were good. Connected the customer back up and no go. We found a power supply problem and then checked for the signals again. OH NO, it won't stay connected. Did a scan. Noise cycles over about 8 seconds like this: 93 85 70 50 65 70 85 95 So this morning I ran scans from 2 other towers with XR9 APs. They are doing the same thing. Direction doesn't seem to matter, but I did not leave APs in scan mode with customers down long enough to get good numbers based on direction. Any suggestions as to what I am looking for?
-- Scott Reed Owner NewWays Networking, LLC Wireless Networking Network Design, Installation and Administration Mikrotik Advanced Certified www.nwwnet.net (765) 855-1060 -------------------------------------------------------------------------------- WISPA Wants You! Join today! http://signup.wispa.org/ -------------------------------------------------------------------------------- WISPA Wireless List: [email protected] Subscribe/Unsubscribe: http://lists.wispa.org/mailman/listinfo/wireless Archives: http://lists.wispa.org/pipermail/wireless/
