Hi, Any MT gurus hanging out tonight. We have a powerouter 732 that we upgraded from v3.22 to 4.17 tonight. When we upgraded it complained about a new license and we did the automatic upgrade and it rebooted just fine. The problem is that I cannot reach it now via the public ip addresses. Was working great before the upgrade. I can access it just fine over the two routed internal interfaces but not the masq interfaces. We have three different sources of bandwidth on 3 of the ethernet interfaces and two of the ethernet interfaces have our rfc1918 addresses with clients on them. There are masq statements for each of the 3 bandwidth interfaces for 192.168.0.0/16 to only go out that particular interface. We then use policy routing to send the traffic out the different interfaces. It was working fine until the upgrade. Now torch shows that there is no traffic going over the interfaces. If you go to the nat statements and look at the masq statements, the counters are increasing like they are being hit but the traffic is not leaving the interface.
Any idea what may be happening or more importantly what information is needed to properly get this working again and fixed? Worked very well before and to my eyes, everything looks good. Thanks
-------------------------------------------------------------------------------- WISPA Wants You! Join today! http://signup.wispa.org/ -------------------------------------------------------------------------------- WISPA Wireless List: [email protected] Subscribe/Unsubscribe: http://lists.wispa.org/mailman/listinfo/wireless Archives: http://lists.wispa.org/pipermail/wireless/
