I've had it a bunch. Like 4 times now. The slit drains the water but each time I also disable reset in the config. I try to disable it everywhere. If only Air control worked...
Josh Luthman Office: 937-552-2340 Direct: 937-552-2343 1100 Wayne St Suite 1337 Troy, OH 45373 On Dec 5, 2012 5:52 PM, "~NGL~" <[email protected]> wrote: > ** > Water could be correct, we have had about 5 inches of rain in the last > week. > I will check that out. > Will cutting a slit in the cable solve the water problem? > Thanx for the info! > NGL > > *From:* Josh Luthman <[email protected]> > *Sent:* Wednesday, December 05, 2012 2:42 PM > *To:* WISPA General List <[email protected]> > *Subject:* Re: [WISPA] Bullet2 HP reverting to factory defaults! > > Water in the line or a busted poe. > > New poe. Cut a slit at the low point of the cable. > > Josh Luthman > Office: 937-552-2340 > Direct: 937-552-2343 > 1100 Wayne St > Suite 1337 > Troy, OH 45373 > On Dec 5, 2012 5:40 PM, "~NGL~" <[email protected]> wrote: > >> ** >> I have had 2 Bullet2 HP reverting to factory defaults! >> 1 was an AP. >> The other was a client. >> >> They were working just as they should and both did a default >> change without notice. >> Both have been installed about 6 months. >> This happened about 2 days apart. >> The AP is on one tower and the client's AP is on another tower' >> Ant ideas as to what is causing this ? >> >> Thanx >> NGL >> >> >> _______________________________________________ >> Wireless mailing list >> [email protected] >> http://lists.wispa.org/mailman/listinfo/wireless >> >> ------------------------------ > > _______________________________________________ > Wireless mailing list > [email protected] > http://lists.wispa.org/mailman/listinfo/wireless > > > _______________________________________________ > Wireless mailing list > [email protected] > http://lists.wispa.org/mailman/listinfo/wireless > >
_______________________________________________ Wireless mailing list [email protected] http://lists.wispa.org/mailman/listinfo/wireless
