Example: If I had 4 Bullet M2s which draw 7 Watts each I would be drawing 28 watts total for the bullets. How much more wattage should I allow for the TS5? Thanx NGL From: Josh Luthman Sent: Tuesday, September 24, 2013 2:30 PM To: WISPA General List Subject: Re: [WISPA] ToughSwitch Question
Connection? I think it'd have to be passing traffic. There is only one processor for wifi and cpu - it's already ticking upon power and association would be negligible. From my tests on DC (from batteries) association had no relevance. Josh Luthman Office: 937-552-2340 Direct: 937-552-2343 1100 Wayne St Suite 1337 Troy, OH 45373 On Tue, Sep 24, 2013 at 5:25 PM, Clay Stewart <[email protected]> wrote: I would think the radio will have to have a connection to use full amps. On Tue, Sep 24, 2013 at 4:51 PM, Josh Luthman <[email protected]> wrote: So funny story - my original ToughSwitch died sometime between Friday and today. This came from Ubnt themselves in Vegas last year (it almost made it a year). So I took the new one in the box and put it in. I did all of the measurements on the AC side because I have a cord that enables me to easily do this. To measure the DC side, I'd have to cut open the wiring and I'd probably throw it away afterwards. 121.4 to 122.2 vac default (powered on, logged into it) 0.05 amp enabled all 5 poe ports (24v) no change put on old ns2 got .07 amps put on ns5m got .09 amps Now I'm not very confident in saying a Ubnt radio is only 2.5 watts (122vac * 0.02amps), but at idle I can't say that's impossible. It definitely went up another 0.01 amps while booting, but lost it when it was fully booted. Josh Luthman Office: 937-552-2340 Direct: 937-552-2343 1100 Wayne St Suite 1337 Troy, OH 45373 On Tue, Sep 24, 2013 at 4:03 PM, ~NGL~ <[email protected]> wrote: 4 ports will be POE, 1 will be a switch NGL From: Randy Cosby Sent: Tuesday, September 24, 2013 12:45 PM To: WISPA General List Subject: Re: [WISPA] ToughSwitch Question Better also plan on how many ports will have POE turned on -- even if you don't have load on them yet to measure against. Turning the relays "on" takes more power. On 9/24/2013 1:32 PM, ~NGL~ wrote: Thanx, I really need to know. NGL From: Josh Luthman Sent: Tuesday, September 24, 2013 11:06 AM To: WISPA General List Subject: Re: [WISPA] ToughSwitch Question If you can't get the answer let me know, I have an amp meter and a NIB ToughSwitch. Josh Luthman Office: 937-552-2340 Direct: 937-552-2343 1100 Wayne St Suite 1337 Troy, OH 45373 On Tue, Sep 24, 2013 at 1:55 PM, Clay Stewart <[email protected]> wrote: DO not know off hand, but what I do is use an APC UPS unit with LED power wattage info, plug in the item I want to know the true wattage and these guys will give it too you. More accurate then a spec sheet ;') On Tue, Sep 24, 2013 at 12:18 PM, ~NGL~ <[email protected]> wrote: Anyone know the wattage a ToughSwitch 5 port uses when powered directly by a 24 volt battery system. I need to be sure I have enough solar to keep tha system up Thanx NGL If you can read this Thank A Teacher. And if it's in English Thank A Soldier! _______________________________________________ Wireless mailing list [email protected] http://lists.wispa.org/mailman/listinfo/wireless -- -- SCS Clay Stewart CEO, Tye River Farms, Inc., DBA Stewart Computer Services 434.263.6363 O 434.942.6510 C [email protected] “We Keep You Up and Running” Wireless Broadband Programming Network Services _______________________________________________ Wireless mailing list [email protected] http://lists.wispa.org/mailman/listinfo/wireless ------------------------------------------------------------------ _______________________________________________ Wireless mailing list [email protected] http://lists.wispa.org/mailman/listinfo/wireless _______________________________________________ Wireless mailing list [email protected] http://lists.wispa.org/mailman/listinfo/wireless -- Randy Cosby InfoWest, Inc 435-674-0165 x 2010 ---------------------------------------------------------------------- _______________________________________________ Wireless mailing list [email protected] http://lists.wispa.org/mailman/listinfo/wireless _______________________________________________ Wireless mailing list [email protected] http://lists.wispa.org/mailman/listinfo/wireless _______________________________________________ Wireless mailing list [email protected] http://lists.wispa.org/mailman/listinfo/wireless -- -- SCS Clay Stewart CEO, Tye River Farms, Inc., DBA Stewart Computer Services 434.263.6363 O 434.942.6510 C [email protected] “We Keep You Up and Running” Wireless Broadband Programming Network Services _______________________________________________ Wireless mailing list [email protected] http://lists.wispa.org/mailman/listinfo/wireless ------------------------------------------------------------------------------ _______________________________________________ Wireless mailing list [email protected] http://lists.wispa.org/mailman/listinfo/wireless
<<image/gif>>
_______________________________________________ Wireless mailing list [email protected] http://lists.wispa.org/mailman/listinfo/wireless
