Update....   Last week we (along with other RF users in the community) were 
invited to the AFB to meet the folks that run the radar there and to see the 
spectrum analyzer screens.  During this meeting, it was discussed that what the 
AF was trying to accomplish was to remove all users within 60Km from using 
5630-5800Mhz.  It was discussed that this seemed to be a doomed request because 
of the sheer number of users in the spectrum within such a large geographical 
area.  How would they remove all users from this spectrum, even within several 
miles of the radar...  lots of hotels, condos, businesses etc...  literally 
thousands of them.  I'm not sure if they are going after the low hanging 
identifiable fruit or if they really plan on going door to door...  They said 
things were sort of in a holding pattern with the FCC because they were 
contacted by a WISPA rep and others and there were some discussions going on 
above our pay grade locally.

 Well, here we are today.  I guess the outcome of those meetings was that we 
need to stop using the spectrum identified.  Here is the email sent from the 
FCC field officer to the local range folks that was forwarded to me:

 =======================================
 FROM: FCC Agent
 TO: CONNOLLEY, SCOTT D GS-13 USAF AFSPC 45 SCS/SCOT

Subject:  Meeting  to  discuss  Interference  to  Radar  at  Patrick AFB

 Scott,  I've  reviewed  your  report  concerning  radio  interference  to  a  
C-Band  (5  GHz)  tracking
radar  at  Patrick AFB.  I  understand  that  you  have  contacted  several  of 
 the Wireless  Internet
Service  Providers  (WISP's)  in  the  area  to  advise  them  of  the  problem 
 and  have  been  met  with
some  resistance  to  assist  you.
I  would  like  to  have  a  meeting  with  you  and  the WISP's  to  discuss  
this  problem  and  open  up  a
discussion  as  to what  steps  can  be  taken  to  find  a  solution.
WISP's  operate  under  Part  15  of  the  FCC  Rules  and  may  not  cause  
harmful  interference.
47  C.F.R.  §  15.5  General  conditions  of  operation.
(a)  Persons  operating  intentional  or  unintentional  radiators  shall  not  
be  deemed  to  have  any
vested  or  recognizable  right  to  continued  use  of  any  given  frequency  
by  virtue  of  prior
registration  or  certification  of  equipment,  or,  for  power  line  carrier 
 systems,  on  the  basis
of  prior  notification  of  use  pursuant  to  §90.35(g)  of  this  chapter.
(b)  Operation  of  an  intentional,  unintentional,  or  incidental  radiator  
is  subject  to  the
conditions  that  no  harmful  interference  is  caused  and  that  
interference  must  be  accepted  that
may  be  caused  by  the  operation  of  an  authorized  radio  station,  by  
another  intentional  or
unintentional  radiator,  by  industrial,  scientific  and  medical  (ISM)  
equipment,  or  by  an
incidental  radiator.
(c)  The  operator  of  a  radio  frequency  device  shall  be  required  to  
cease  operating  the  device
upon  notification  by  a  Commission  representative  that  the  device  is  
causing  harmful
interference.  Operation  shall  not  resume  until  the  condition  causing  
the  harmful  interference
has  been  corrected.
(d)  Intentional  radiators  that  produce  Class  B emissions  (damped  wave)  
are  prohibited.

 I  propose  that  we  have  our  first meeting  on  Wednesday,  6/18/14,  at  
Patrick AFB.

 Thanks,
Don  Roberson
Sr.  Agent
Tampa  Office
Enforcement  Bureau
FCC
Office:  813-348-1741  ext  105

 =======================================

 So, its that easy?  Local AF guy makes a request whether reasonable or not, 
and thats the way it is?  I understand moving off the 5765Mhz and having guard 
space on either side maybe 20Mhz, but they want the whole band to stop being 
used  whether its even in the radar LOS or not, which is an unreasonable 
request, IMO.  This meeting of the minds will apparently happen this coming 
Wednesday here locally. Anyone have anything to add, other than good luck?

 Scott Carullo
Technical Operations
855-FLSPEED x102



----------------------------------------
 From: "Jack Unger" <[email protected]>
Sent: Monday, June 02, 2014 12:49 PM
To: [email protected]
Subject: Re: [WISPA] USAF Request - Read this is you want to keep using 
5630-5800 Mhz
Yes. Thanks !
  On 6/2/2014 9:24 AM, Scott Carullo wrote:
  Does this work:


 Scott Connolley, GS-13, DAF DoD Eastern Area Frequency Coordination Office 45 
Space Communications Squadron Patrick Air Force Base Florida COMM: (321) 
494-5838 DSN 854  [email protected]



 Scott Carullo
Technical Operations
855-FLSPEED x102



----------------------------------------
 From: "Jack Unger" <[email protected]>
Sent: Monday, June 02, 2014 12:20 PM
To: "WISPA General List" <[email protected]>
Subject: Re: [WISPA] USAF Request - Read this is you want to keep using 
5630-5800 Mhz
 Guys,

I'm working on getting some clarification on this issue. Let's try to hold off 
on the public speculation for a little while on this very public email list 
while I try to get more information.

If anyone has additional concrete information, please email it to me. 
Specifically, does anyone have a link to DoD Eastern Area Frequency 
Coordination Office?

Thanks,
                   jack
    On 6/2/2014 9:13 AM, Patrick Leary wrote:

I'd be shocked if the military could claim unilateral authority for restricting 
170 MHz of long-established ISM spectrum (nor 120 MHz of UNII). I hope we read 
an authoritative opinion via from Steve Coran.



Patrick Leary

M 727.501.3735







From: [email protected] [mailto:[email protected]] On Behalf 
Of Scott Carullo
Sent: Monday, June 02, 2014 11:52 AM
To: [email protected]; WISPA General List; [email protected]
Subject: [WISPA] USAF Request - Read this is you want to keep using 5630-5800 
Mhz



I am following up in hopes that some of you smart fellas can offer suggestions.



Recap:

USAF Calls / emails asking to please identify all 5Ghz emitters operating on or 
near 5765Mhz and either turn them off or change RF settings to not fall under 
that category so that RFI to their tracking radar can be reduced.



How the radar works:  Apparently the radar has multiple modes for tracking / 
interrogating space-bound craft.  In its primary mode, it sends a pulse out on 
5672Mhz and then listens for the echo (normal radar operation).  It then has 
another mode, where it sends an interrogation request to the vehicle (satellite 
/ rocket etc) on 5690Mhz and then listens for a reply from the vehicle on 
5765Mhz at least for some commercial space launches.  DoD military launches 
etc. also are tracked / interrogated this same way but the listen freq. is 
something other than 5765Mhz (probably classified).  So - the prob the USAF has 
with RFI is related to hearing the vehicle interrogation response on 5765Mhz - 
and only while sitting on the pad and the first few seconds of flight.  A few 
seconds after launch, the gigantic parabolic dish (~65db gain on 5Ghz) with its 
<1deg beam-width has effectively muted out most of the RFI to the sides as it 
starts to track up.



We (and others / cable company etc) worked with them to not only re-program our 
equipment we felt could be causing RFI to their radar, but to track down others 
we could see operating equipment centered on their 5765Mhz freq.  We were able 
to continue this process until the radar was able to track / interrogate 
successfully, from what information I was relayed.  We attempted to work with 
them to be good neighbors and hopefully avoid a situation where we were told 
all emitters regardless of their effect on the radar (even ones that were not 
causing them issues) would need to be removed from service in some fashion.



Here we are today.  The USAF has now decided to create a 60Km zone around each 
of their tracking radars and request that we not only keep equipment off the 
5765Mhz they listen on but everything in the range from 5630 - 5800 Mhz just 
for good measure.  I feel such a blanket request is not reasonable.



Cut and past from their DoD Eastern Area Frequency Coordination Office:

===========



 Mr WISP,



 I received the 5 GHz exclusion the range is requesting around their radars

 (Graphic available here: http://flhsi.com/files/radar.PNG ).

 The spheres are centered on each radar and have a radius of 60 km.  No

 emitters in these spheres should be allowed to transmit from 5630 - 5800

 MHz.



 I am drafting up a request for public notice to FCC today.  When approved, I

 will let you know.

===========



So my question is this....  Is it realistic or even remotely possible this 
becomes an FCC official rule?



I would ask anyone / everyone with a vested interest in this (do you use 5Ghz?) 
 to respond.  Thank you for your time.



Scott Carullo
Technical Operations
855-FLSPEED x102



----------------------------------------

From: "Scott Carullo" <[email protected]>
Sent: Wednesday, May 07, 2014 12:02 PM
To: [email protected]
Subject: [WISPA] Air Force Base / KSC Launch RFI Question



Good morning,



We operate between two local Air Force bases and near KSC as well.  We were 
notified recently that the AFB has resorted to using an older radar system that 
was previously retired due to the newer range radar system catching fire or 
something to that effect.  During the two months or so the repairs are expected 
to take we have had several space launches scheduled during this window from 
CCAFS / KSC.  The USAF has fired up the old radar and has recently contacted us 
asking about equipment we have in the area at customer premises.  I asked the 
frequency coordinator what freq their radar uses he said the center freq was 
5735 and that it had a very wide bandwidth of like 100 Mhz basically taking the 
whole ISM/UNII bands worth of spectrum in 5Ghz.



So any way to the point...  When the USAF shows up and says hey, I see you are 
using FCC approved equipment in accordance to the FCC spectrum rules the 
equipment was designed to operate in on freq 5765Mhz - but I need you to turn 
it off to see if its your equipment we are seeing - and if it is please change 
freq "preferably below 5600 MHz or above 5850 MHz" (actual quoted request).



Obviously we can't accommodate their request for several reasons,most notably 
because the equipment nor the FCC allows it.  I'm just curious if any of you 
have had anything like this happen and what your response was / would be.



I try to be a nice neighbor and work with them any way possible but them trying 
to shut down the whole 5Ghz non-licensed upper band all our equipment uses 
(including every other cable and wireline providers wifi 5Ghz equipment in the 
county) to work their range RFI issues is a bit much and ultimately 
unattainable within the 3 days they have left prior to launch, IMO.



Any insight or suggestions you smart fellers have would be appreciated.  I am 
particularly interested in those more intimate with FCC rules regarding this 
situation.  Do I have to comply?  Do they have legal justification to just say 
- turn it off...  etc



Thanks...   I appreciate your time in responding.



Scott Carullo
Technical Operations
855-FLSPEED x102

************************************************************************************
This footnote confirms that this email message has been scanned by
PineApp Mail-SeCure for the presence of malicious code, vandals & computer 
viruses.
************************************************************************************

************************************************************************************
This footnote confirms that this email message has been scanned by
PineApp Mail-SeCure for the presence of malicious code, vandals & computer 
viruses.
************************************************************************************



 _______________________________________________ Wireless mailing list 
[email protected] http://lists.wispa.org/mailman/listinfo/wireless

 --  Jack Unger - President, Ask-Wi.Com, Inc. Author (2003) - "Deploying 
License-Free Wireless Wide-Area Networks" Serving the WISP Community since 1993 
760-678-5033  [email protected]


 --  Jack Unger - President, Ask-Wi.Com, Inc. Author (2003) - "Deploying 
License-Free Wireless Wide-Area Networks" Serving the WISP Community since 1993 
760-678-5033  [email protected]

_______________________________________________
Wireless mailing list
[email protected]
http://lists.wispa.org/mailman/listinfo/wireless

Reply via email to