Hi,
You
have to write a dissector for your protocol and have it register for the TCP
port used in order to have the protocol dissected.
Brg
Anders
From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of [EMAIL PROTECTED]
Sent: den 5 september 2006 05:38
To: [email protected]
Subject: Re: [Wireshark-dev] A question about ASN.1 encoding in wireshark
Hi,
I made a ASN1 based message on TCP, but could not get
anything displayed after TCP in wireshark. by default it used ENTTEC after TCP.
From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of ext Anders Broman (AL/EAB)
Sent: Wednesday, August 30, 2006 4:09 PM
To: Developer support list for Wireshark
Subject: Re: [Wireshark-dev] A question about ASN.1 encoding in wireshark
Hi,
Do you
get anything displayed after TCP?
See http://wiki.wireshark.org/Asn2wrs on
how to design an asn1 based dissector using asn2wrs.
Best
regards
Anders
From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of [EMAIL PROTECTED]
Sent: den 30 augusti 2006 04:03
To: [email protected]
Subject: [Wireshark-dev] A question about ASN.1 encoding in wireshark
Hi All,
I have a question about ASN.1 decoding in wirshark, hope can get someone's help.
I have my own defined ASN.1 messages, these messages are decoded with BER, the messages transfer based on TCP/IP, wireshark can capture the messages, and decode the message, but can not display the field name in the detailed information area.
I want to add my ASN.1 definitions in wireshark, and can decode/show the message correctly in the detailed information area in the wireshark, but I do not know how to proceed, it there any one can share the experiences or send me some useful materials?
Thank you very much,
Chris
_______________________________________________ Wireshark-dev mailing list [email protected] http://www.wireshark.org/mailman/listinfo/wireshark-dev
