Jim Pickering wrote: > I am new to the mailing list and am in the process of developing a > protocol dissector. > > I downloaded the source and build the executable on Windows XP. > Everything went quite well. Kudos to the development team. > > I ran the built app > (C:\wireshark>C:\wireshark\wireshark-gtk2\wireshark.exe), selected > "Capture", selected "Interfaces", hit "Start" on my "Broadcom NetXtreme > Gigabit Ethernet Driver", and it > crashes with the following: > AppName: wireshark.exe AppVer: 0.99.5.0 ModName: msvcr80.dll > ModVer: 8.0.50727.762 Offset: 0001ebf3 > > This does not happen with the executable I downloaded. > > Built executable from source is Version 0.99.5 > Downloaded executable is Version 0.99.5 (SVN Rev 20677) > > I am dying to get started on my protocol dissector, but this is holding > me up! > > Any ideas? Can I supply any more information? >
You don't indicate your build environment, but as msvcr80.dll is mentioned I assume that you're using VS2005 in some form. If this is the case, I think the problem is likely to be adns_dll.dll. The version that is downloaded is built with VC6, and doesn't play well with VS2005 (VC8). Open the adns project (adns_win32.dsw) in VS2005, convert it to the VS2005 project format and rebuild it. Link wireshark again and you should be good to go. -- Regards, Graham Bloice _______________________________________________ Wireshark-dev mailing list Wireshark-dev@wireshark.org http://www.wireshark.org/mailman/listinfo/wireshark-dev