Hi, This is currently not possible you will have to add code to the FP Dissector (packet-umts-fp.c I believe) As Martin indicated: >add preferences to the FP dissector to set default values for some of these >in the absence of complete configuration...
and if I understand correctly you then have to write code to handle >... but I don't think you'll have RRC directly over FP, you'll have MAC and >RLC. If you don't care about displaying their details, you still need to >understand them to skip their headers properly and reassemble their data. Regards Anders -----Ursprungligt meddelande----- Från: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] För [EMAIL PROTECTED] Skickat: den 9 augusti 2007 13:06 Till: [email protected] Ämne: [Wireshark-dev] I am not able to decode FP messages. Hi, I want to decode FP messages over UDP and RRC messages. Please tell How to set default values for FP dissector and how to configure. Thanks & Regards, Vaibhav *********************** Aricent-Unclassified *********************** "DISCLAIMER: This message is proprietary to Aricent and is intended solely for the use of the individual to whom it is addressed. It may contain privileged or confidential information and should not be circulated or used for any purpose other than for what it is intended. If you have received this message in error, please notify the originator immediately. If you are not the intended recipient, you are notified that you are strictly prohibited from using, copying, altering, or disclosing the contents of this message. Aricent accepts no responsibility for loss or damage arising from the use of the information transmitted by this email including damage from virus." _______________________________________________ Wireshark-dev mailing list [email protected] http://www.wireshark.org/mailman/listinfo/wireshark-dev _______________________________________________ Wireshark-dev mailing list [email protected] http://www.wireshark.org/mailman/listinfo/wireshark-dev
