Hi, I had a similar problem and the easiest way was adding a prepared SDP frame to the beginning of the captured file.
Best regards, Balint 2008. 11. 17, hétfő keltezéssel 18.52-kor Anders Broman ezt írta: > Hi, > I think rtp_add_address() should do it, see packet-uma.c SIP RTCP etc. > You might have to add debug code to see where it fails...( if(tree) > causing problems?). > Regards > Anders > > -----Original Message----- > From: [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED] On Behalf Of Michael Lum > Sent: den 17 november 2008 17:59 > To: Developer support list for Wireshark > Subject: Re: [Wireshark-dev] How do you get RTP recognized by Wireshark > ? > > Yes, I've tried that, thanks. > > Wireshark shows the packets as RTP but does not know the payload type. > > I would like to make modifications to the source so that Wireshark will > understand the CODECs specified in the IOS5 signaling and then > subsequently call another dissector for RFC3558. > > Thanks. > > > -- > Michael Lum Principal Software Engineer > 4600 Jacombs Road +1.604.276.0055 > Richmond, B.C. > Canada V6V 3B1 > Star Solutions > -----Original Message----- > From: [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED] On Behalf Of Abhik Sarkar > Sent: November 15, 2008 1:53 AM > To: Developer support list for Wireshark > Subject: Re: [Wireshark-dev] How do you get RTP recognized by Wireshark > ? > > Hi Michael, > > I don't know much about RTP, but I think I remember someone answering a > similar question recently... have you already trying turning on the > preference for RTP protocol called "Try to decode RTP outside of > conversations"?. > > HTH > Abhik. > > On Fri, Nov 14, 2008 at 10:06 PM, Michael Lum > <[EMAIL PROTECTED]> wrote: > > Hi, > > > > I have RTP streams that are set up with an unrecognized signaling > > protocol. I.e. not SIP/MGCP, etc. > > > > Can somebody give me a quick run down on what to change so that the > > streams can be recognized as RTP ? > > > > I thought all I might have to do was add a call to > > rtp_add_address() with the correct IP address, port, payload, etc. > > but it doesn't appear to work. > > > > Any help would be great. > > > > Thanks. > > > > -- > > Michael Lum Principal Software Engineer > > 4600 Jacombs Road +1.604.276.0055 > > Richmond, B.C. > > Canada V6V 3B1 > > Star Solutions > > _______________________________________________ > > Wireshark-dev mailing list > > [email protected] > > https://wireshark.org/mailman/listinfo/wireshark-dev > > > _______________________________________________ > Wireshark-dev mailing list > [email protected] > https://wireshark.org/mailman/listinfo/wireshark-dev > _______________________________________________ > Wireshark-dev mailing list > [email protected] > https://wireshark.org/mailman/listinfo/wireshark-dev > _______________________________________________ > Wireshark-dev mailing list > [email protected] > https://wireshark.org/mailman/listinfo/wireshark-dev _______________________________________________ Wireshark-dev mailing list [email protected] https://wireshark.org/mailman/listinfo/wireshark-dev
