Thanks a lot, that exactly solves the problem that I have been facing. On Wed, Dec 24, 2008 at 3:11 PM, Sake Blok <[email protected]> wrote:
> Hi Mahendran, > > I can reproduce your issue when I disable "Allow subdissector to reassemble > TCP streams". When I have that setting enabled, packet 47,51 and 55 show up > fine. > > Can you check that setting in the TCP protocol preferences and enable it if > it was disabled (as I would expect, based on your findings). > > Cheers, > Sake > > ----- Original Message ----- > *From:* Mahendran <[email protected]> > *To:* [email protected] > *Sent:* Tuesday, December 23, 2008 7:51 PM > *Subject:* [Wireshark-dev] Parsing SMB Packet > > Hi, > > I am using Wire Shark 1.0.5. > > I am trying to capture the SMB packets using Wire Shark. It parses the SMB > Request correctly but unable to parse the SBM Response that is sent from our > device. The content are shown under "Continuation Data". If it parses > properly that will help me in analyzing the packets. Could you please help > me? > > I have attached the capture for your analysis. Look at the packet no 47, 51 > and 55. > > Best Regards, > Mahendran > > ------------------------------ > > ___________________________________________________________________________ > Sent via: Wireshark-dev mailing list <[email protected]> > Archives: http://www.wireshark.org/lists/wireshark-dev > Unsubscribe: https://wireshark.org/mailman/options/wireshark-dev > mailto:[email protected] > ?subject=unsubscribe > > > ___________________________________________________________________________ > Sent via: Wireshark-dev mailing list <[email protected]> > Archives: http://www.wireshark.org/lists/wireshark-dev > Unsubscribe: https://wireshark.org/mailman/options/wireshark-dev > mailto:[email protected]?subject=unsubscribe >
___________________________________________________________________________ Sent via: Wireshark-dev mailing list <[email protected]> Archives: http://www.wireshark.org/lists/wireshark-dev Unsubscribe: https://wireshark.org/mailman/options/wireshark-dev mailto:[email protected]?subject=unsubscribe
