I'm trying to pre-package some MIB files for the company here and smi.dll is
causing an error. I created a directory variable in config.nmake that holds
the MIB files. I edited Makefile.nmake below '!IFDEF SMI_DIR...!ENDIF' and
added the following:
!IFDEF MY_DIR
if not exist $(INSTALL_DIR)\snmp mkdir $(INSTALL_DIR)\snmp
if not exist $(INSTALL_DIR)\snmp\mibs mkdir $(INSTALL_DIR)\snmp\mibs
xcopy "$(MY_DIR)\*" $(INSTALL_DIR)\snmp\mibs /d
!ENDIF
The files are copied to the folder. But then then next line executed in the
build process is:
wireshark-gtk2\tshark.exe -G | perl doc\dfilter2pod.pl
doc\wireshark-filter.pod.template > doc\wireshark-filter.pod
And then a popup "TShark has encountered a problem and needs to close...." I
click through for more information and it blames smi.dll:
AppName: tshark.exe AppVer: 1.1.4.1 ModName: smi.dll
ModVer: 0.0.0.0 Offset: 0000aafc
The syntax for my MIBs seems ok; I can load them in Wireshark post-install &
also in other browsers without problem. If I click OK and continue the
process, it finishes without more problems. But when I run
wireshark-gtk2/tshark.exe, it throws the same error. I'm stumped on where to
look next.
--
Rick
___________________________________________________________________________
Sent via: Wireshark-dev mailing list <[email protected]>
Archives: http://www.wireshark.org/lists/wireshark-dev
Unsubscribe: https://wireshark.org/mailman/options/wireshark-dev
mailto:[email protected]?subject=unsubscribe
