Hi
I am unable to get the output of Rawshark.
I have a packet structure as below when decoded with Wireshark.
Ethernet II
802.1Q VLAN
IP
When I execute the following I am getting following error:
$ rawshark -d encap:105 -r packet-name -F ip.src -s
0 FT_IPv4 BASE_NONE -
rawshark: "packet-name" is neither an interface nor a pipe
How to use the rawshark to get the output of Source IP address in the packet?
Can anyone help me?
Regards,
Atdev
Please do not print this email unless it is absolutely necessary.
The information contained in this electronic message and any attachments to
this message are intended for the exclusive use of the addressee(s) and may
contain proprietary, confidential or privileged information. If you are not the
intended recipient, you should not disseminate, distribute or copy this e-mail.
Please notify the sender immediately and destroy all copies of this message and
any attachments.
WARNING: Computer viruses can be transmitted via email. The recipient should
check this email and any attachments for the presence of viruses. The company
accepts no liability for any damage caused by any virus transmitted by this
email.
www.wipro.com
___________________________________________________________________________
Sent via: Wireshark-dev mailing list <[email protected]>
Archives: http://www.wireshark.org/lists/wireshark-dev
Unsubscribe: https://wireshark.org/mailman/options/wireshark-dev
mailto:[email protected]?subject=unsubscribe
