On 02/05/2014 04:37 PM, Bill Somerville wrote:
After configuring the audio in and out, one may have to exit wsjtx and
restart it
to get wsjtx working properly.
That shouldn't be necessary Chuck, changing the audio device or channel
selection in configuration should cause the device(s) to be opened from
scratch.
Hi Bill & Chuck !
Restarting the program has changed nothing.
How can I locate the device the error message "QIODevice::read: device
not open" is referring to ?
Please note, that I'm using the following lines in the config file:
CATport=localhost:4532
CATportIndex=5
ClearCallGrid=true
DTR=false
DTRoff=false
DXCCEntity=true
DataBits=8
DataBitsIndex=1
I'm using rigctld. It's a little bit strange to have config lines
referring to the serial port, which is not controlled by wsjtx. Can I be
sure, that wsjtx is not trying to control the serial port ?
The RX/TX switching occurs, but no audio signal is sent to the
transceiver. I will have to debug the problem further. Any good idea
will be welcome.
Thanking you a lot !
Best 88 de Claude
_______________________________________________
Wsjt-devel mailing list
[email protected]
https://lists.berlios.de/mailman/listinfo/wsjt-devel
