Thank you for the reply,
Things are slowly coming together. While Makefile.MinGW appears to be the
most correct makefile it
contains support for angelia and none of the referenced files are in the
distribution A grep of all the files
showed that the makefile was the only place angelia showed up so I cleaned
all references and got to the next stage.
I did install the makefile listed version of the installer
(pyinstaller-1.5.1) and then based on an error I was getting about the
configure file being non existant or corrupt ran the configure.py for it.
That cleaned up that issues.
The make is now bombing out in the section creating Audio.pyd with the
following error:
error: unknown file type '' (from '-fbounds-check')
(that is two single quotes)
I have played around a bit with the --opt line including the bad idea of
removing it... in that case the make continues on and after tons of warning
produces an file that does not execute correctly. Nothing seems to get it
past that stage.
I have tried both gfortran and g95 with the same results.
I would appreciate hearing from anyone who has seen something similar. This
appears to be something with the python setup so will likely be next
weekends project.
Thanks in advance for any help!!
73 de Bill ND0B
-----Original Message-----
From: Joe Taylor
Sent: Saturday, February 08, 2014 4:19 PM
To: WSJT Devel
Subject: Re: [Wsjt-devel] Tool chain and make file to compile WSJT
underwindows.
Hi Bill,
On 2/8/2014 11:20 AM, Bill Ockert - ND0B wrote:
Good morning,
I am attempting to get the tool chain set up to compile WSJT under
windows.
The blip on the WSJT page says “To compile the programs for Windows you
can use the MinGW system and g95. You will also need the python packages
listed above.”
That packages listed above are
subversion
a.. python2.x-dev
a.. python-numpy
a.. python-imaging-tk
a.. python-pmw
a.. libportaudio2
a.. libportaudio-dev
a.. libsamplerate0-dev
a.. libfftw3-dev
a.. gfortran or g95
So far I have loaded MingW and seem to be compiling fortran OK.
I have loaded Python 2.7 and Numpy, I am working on loading imaging-tk and
pmw.
Question: Are the lib* libraries required under windows? I not sure
how to interpret the “python packages” comment above.
It simply means you need to install the packages in the list.
Question: Is Makefile.MinGW the correct make file to use for development
under windows with MinGw?
Yes.
You might need to tweak the Makefile according to your own paths, etc.
To get through all the steps in the Makefile you'll also need to install
pyInstaller, which makes an executable wsjt9.exe that contains python
and all the needed modules. To run the program on your own machine,
however, you don't need the "pyInstaller" step.
Any pointers to get the windows based tool chain set up would be greatly
appreciated.
Thanks!!
73 de Bill ND0B
-- 73 and GL de Joe, K1JT
_______________________________________________
Wsjt-devel mailing list
[email protected]
https://lists.berlios.de/mailman/listinfo/wsjt-devel
_______________________________________________
Wsjt-devel mailing list
[email protected]
https://lists.berlios.de/mailman/listinfo/wsjt-devel
