On 06/06/2015 17:11, Josh Rovero wrote:
Hi Josh,
I have reset working frequencies, refilled the WSPR Band Hopping matrix,
set and reset Tx Enable. Still getting periodic Rig Control Errors
that were
not present in previous versions that were band hopping (with and
without tuning prior to transmission).
The rig control issues may well be due to some rather more fundamental
than I would wish changes to ensure split mode is not inadvertently used
in WSPR mode. What is the error you are getting and what is you rig and
interface/PTT arrangement?
Since r5546 tune should only happen when band hopping to a band that is
marked for tune and is not going to be transmitted on immediately.
Setting just "Tx Enable" results in no transmission over a two hour
period. Setting "TX Enable" and "Tx Next" gets a transmission started.
Then no further transmissions, and "Tx Enable" is un-set.
Some revisions prior to r5546 did have defects that would cause no Tx
periods for various reasons. What Tx Pct value do you have set?
Are you certain there were no Tx periods? I ask because the activity log
on the screen does not include Tx periods unless the option
"Settings->General->Tx Message to Rx Frequency Window" is checked. The
file ~/.local/share/WSJT-X/WSPR_ALL.TXT will always indicate any Tx periods.
Nothing in my physical setup has changed, just the wsjtx version.
Building and running on FC20 x86_64.
--
P.J. "Josh" Rovero Ham Radio: KK1D
http://www.roveroresearch. <http://www.roveroresearch.org>net
http://www.roveroresearch.info
73
Bill
G4WJS.
------------------------------------------------------------------------------
_______________________________________________
wsjt-devel mailing list
wsjt-devel@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
