I have done that ...but that didnt answer the problem
73 David VK4BDJ
On 09/08/16 06:20, Craig Treubig wrote:
RE: [wsjt-devel] WSJTX latest versions Try recompiling hamlib
-----Original message-----
*From:* David
*Sent:* Sunday, August 7 2016, 9:30 pm
*To:* WSJT software development
*Subject:* [wsjt-devel] WSJTX latest versions
Hi Bill and Joe.....WSJTX-r6947 when using to TX or Tune on a FT-450D
when it goes back to RX a RigControl error comes up and shows Hamlib
error :Bus collision while setting Frequency......this has only started
recently with 1.7.0
r6947 on...I also have compiled the latest rRC1 and it still does it....
at bills suggestion i tried it with a Dummy load so its not a Antenna
problem
and it still does the same error...have tried version 1.6.1 and it works
100%
so i dont now if its a bug in the latest versions
any suggestions
--
73 David VK4BDJ
------------------------------------------------------------------------------
_______________________________________________
wsjt-devel mailing list
wsjt-devel@lists.sourceforge.net
<mailto:wsjt-devel@lists.sourceforge.net>
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
------------------------------------------------------------------------------
What NetFlow Analyzer can do for you? Monitors network bandwidth and traffic
patterns at an interface-level. Reveals which users, apps, and protocols are
consuming the most bandwidth. Provides multi-vendor support for NetFlow,
J-Flow, sFlow and other flows. Make informed decisions using capacity
planning reports. http://sdm.link/zohodev2dev
_______________________________________________
wsjt-devel mailing list
wsjt-devel@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
