Hi David,
> I noticed the following on r7072 (Running under OSX 10.9.5):
>
> 1) Given a constant audio level input with the JT65 level adjusted
> to 30 dB, I see the correct 30dB audio reading using JT9, JT65,
> JT9+JT65, JT4, QRA64, and WSPR2. Switching to ISCAT, JTMSK or
> MSK144 results in a 5dB drop in the reported signal level.
For a no-longer-important reason, the arbitrary "0 dB" level for fast
modes was defined differently (by 5 dB) than for slow modes. This has
no important consequence; the "sweet spot" for setting a good level is
very broad -- far more than 5 dB wide. However, the offset that
surprised you will be removed.
> 2) I don't use the hamlib rig control (I set it to 'None'). In modes
> ISCAT, JTMSK, MSK144, and QRA64 I am unable to change the band
> dropdown by hand. All the other modes allow it.
Default frequencies for each band are "mode specific". Apparently you
see the behavior you describe because you haven't entered any choices of
default frequencies for ISCAT, JTMSK, MSK144, or QRA64.
-- 73, Joe, K1JT
------------------------------------------------------------------------------
_______________________________________________
wsjt-devel mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
