some more info. This is in jt65 and jt9 mode on at least 40 and 20 meter
bands, icom ic-7300 radio with RTS ptt. The software thinks it is in
transmit mode between :00 and :05, because i can't change the message like
you can between :50 and :59 normally. I hope that's clear. Normally you can
change the message right until it starts to transmit, and then clicking the
radio buttons doesn't do anything (yellow highlighted text in the upper
right field) - but the software thinks i am in TX from :00 - :05 as the
message will not change.
Any other info i can provide. Again, i CAN QSO, and the software works fine
otherwise. the dT (time delta) shows +/-0.1-1.0 seconds.
On Wed, Dec 28, 2016 at 3:02 PM, David Van Rood <[email protected]> wrote:
> time is synced to ntp, and i can make QSO, but the ptt/tx portion doesn't
> start until :05, rather than :00.
>
> The tx delay setting is 0.2, and i can't find any other reason that this
> should be the case. Any other information you would like i am happy to
> oblige.
>
>
> Thanks!
> --
> David Van Rood
> Cloud Research and Engineering
> Dowd & Associates <http://www.dowdandassociates.com/>
> Alexandria, Louisiana
> 714-912-6052 <(714)%20912-6052> (Home)
> 814-HACK-BIT (Cellular)
>
--
David Van Rood
Cloud Research and Engineering
Dowd & Associates <http://www.dowdandassociates.com/>
Alexandria, Louisiana
714-912-6052 (Home)
814-HACK-BIT (Cellular)
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, SlashDot.org! http://sdm.link/slashdot
_______________________________________________
wsjt-devel mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
