This patch changes the TIME_ON determination to the following:
#1 Change of DX Call (not just typing in it but base call change) sets QSO
start time#2 Transmit of grid or CQ resets start time -- this allows for
repeated attempts to start QSO#3 Any other transmission may set start time if
not already set due to non-standard message sequencing.
Tab 2 took a littleextra logic since it behaves differently than Tab 1.
I've temporarily left a little bit of debug in the code. That "Last Tx" status
bar item will show the current QSO start time when it gets set. That should
probably be removed after some testing by other...helps to be able to see what
is going to be used if you're testing a sequence.
https://www.dropbox.com/s/m6byc65bkkabtyx/timeon.patch?dl=1
de Mike W9MDB
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, SlashDot.org! http://sdm.link/slashdot
_______________________________________________
wsjt-devel mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
