I'd say delete it and put a note in the manual about proper frequencies. It
would depend on whether your are just receiving or transmitting too.
de Mike W9MDB
From: Joe Taylor <j...@princeton.edu>
To: wsjt-devel@lists.sourceforge.net
Sent: Tuesday, February 14, 2017 11:27 AM
Subject: [wsjt-devel] Default WSPR frequency on 60 m
Hi all,
Current WSJT-X code has the default frequency for WSPR mode on the 60 m
band set to 5.2872 MHz. If US hams use this frequency they will be
transmitting on 5288700 +/- 100 Hz, which does not conform to our
(rather odd) FCC regulations for this band.
I think this issue has been discussed before, but I'm not sure what the
result was. What's our best policy for WSJT-X? Should we delete the
default WSPR frequency, and caution users to do the right thing,
themselves, depending on their local regulations?
-- Joe, K1JT
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, SlashDot.org! http://sdm.link/slashdot
_______________________________________________
wsjt-devel mailing list
wsjt-devel@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, SlashDot.org! http://sdm.link/slashdot
_______________________________________________
wsjt-devel mailing list
wsjt-devel@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
