Hi Dani Not sure we are seeing exactly the same behaviour.
If I start program having closed from QRA64 then it is active. If then without closing I select eg JT4 then it is greyed out in JT4, as it should be. If I then return to QRA64, without closing the program, it is greyed out. The only way to get it back is to then close and restart. 73 Charlie -----Original Message----- From: Dani EA4GPZ [mailto:[email protected]] Sent: 22 April 2017 10:36 To: WSJT software development Subject: Re: [wsjt-devel] AP for DX call only if VHF/uW enabled El 22/04/17 a las 06:52, Charles Suckling escribió: > Hi Dani > > We have found some time ago that if you have "Enable AP for DX call" active > then open the settings tab to make some other change, after that action > "Enable AP for DX call" becomes greyed out. > > Try making your change (eg to disable VHF and up), close WSJT-X and restart. > You may then find "Enable AP for DX call" is active again. Hi Charlie, Thanks for the tip. I've found that if WSJT-X starts in QRA64 mode (because this was the mode selected when I closed it before), then "Enable AP for DX call" is active regardless of the mode I select. However, if WSJT-X starts in another mode, then "Enable AP for DX call" is grayed out even if I select QRA64. I'm running r7648. 73, Dani. ---------------------------------------------------------------------------- -- Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ wsjt-devel mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/wsjt-devel ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ wsjt-devel mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/wsjt-devel
