Hi George,
please explain in detail what you think is going wrong? The behaviour
Erik described is normal and correct behaviour and allows you to
transmit at *any* DF plus it helps to keep your transmit signal as clean
as possible.
73
Bill
G4WJS.
On 30/06/2017 14:12, George J Molnar wrote:
I see the same, and suggest it not be continued as the normal
behavior. In a multi signal environment, it will likely lead to
confusion.
Using a configuration for FT8 that turns off split capability is a
workaround for now, it seems.
George J Molnar, KF2T
Nevada, USA
On Jun 30, 2017, at 2:01 AM, Bill Somerville <g4...@classdesign.com
<mailto:g4...@classdesign.com>> wrote:
On 30/06/2017 08:18, Erik Icket wrote:
I successfully operate latest build 7752, and in the last 12 hours,
I was able to copy on 14079 the following stations :
OE1MWW, F1ABL, CT1FBK, I3VJW, KB3MOW, AK1P, VA3VF, K9AN, K4DET, WB4KDI
There is however one anomaly with my rig control (ICOM 7100 in SPLIT
mode) :
When I PTT with an RX frequency of 14.079.000, the TX occurs on
14.078.500
Note that the TX and RX spinners are on 1200 Hz as well as the green
and red brackets on the wide graph.
The same happens on any other band (6m ..), whereby the TX is 500 Hz
below the RX frequency
Has anyone else observed this ?
Hi Erik,
this is normal and correct behaviour if you have
"Settings->Radio->Split Operating" set and have selected a Tx DF
between 1000Hz and 1499Hz. Other Tx DF values will select different
Tx dial frequencies to optimize your signal quality and Tx sub-band
coverage.
73
Bill
G4WJS.
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
wsjt-devel mailing list
wsjt-devel@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
