On 06/07/2017 22:45, Rick wrote:
GUI Observations:
Switching configurations does not reset to the appropriate frequency
if you edit the frequency/mode table. If you reset to the defaults,
you can switch back and forth, and the radio will follow, however if
you edit any entry (I changed JT-65 from 50.310 to 50.276) selecting
the configuration for JT-65 leaves the rig set on the previous frequency.
I run two monitors, and keep a lot of the WSJT-X stuff on the right
monitor. I have the Log QSO pop-up window set to show on the left
screen. I have to open any programs I wish to run in the left window,
and then start WSJT-X in order for the Log QSO screen to show on top.
It will not pop up on top of any screens opened after WSJT-X. Not sure
this is a windows 7 issue (64-bit) or something that can be forced. I
probably should move the Log QSO screen on top of the wide graph as a
quick fix.
Hi Rick,
the settings options "Settings->General->Monitor off at startup" and
"Monitor returns to last used frequency" control the behaviour at
startup. Switching configurations is exactly equivalent to starting up
the application when the destination configuration is the last used
configuration.
The "Log QSO" window is not modal, that is necessary because you may
want to complete the QSO using the main window before completing the
logging operation. It should come to the top if you give keyboard focus
to the WSJT-X main window.
73
Bill
G4WJS.
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
wsjt-devel mailing list
wsjt-devel@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
