Bill,

   OK, so the key to starting with the TX2 message is to double click on the 
round bullet to the left of TX1 until the message text is greyed out. Then when 
I click on the CQing station's call, the TX1 message is skipped and the TX2 
message is transmitted...got it.


By doing this, now when a station called does NOT come back to my call, even if 
I use the TX2 message, the red "Enable Tx" button goes grey and my further 
calls to that station are stopped.


Thanks.


BTW, I've been reading the WSJT - Revision 7960: guide at:


/branches/wsjtx/doc/user_guide/en

But I haven't yet found where all of the various shortcut keys are defined.


73,

Rich - K1HTV


= = =


Hi Rich,

how are you selecting Tx2 to reply to a CQ call? If you are doing so by
clicking the buttons next to it then WSJT-X will assume you know what
you are doing and are already in a QSO. To use Tx2 to reply to CQ or QRZ
calls you can double-click either of the buttons next to the Tx1 message
to disable it, it will be greyed out to show that and Tx2 will be
automatically used to reply to make initial calls to stations when you
double click a decode.

73
Bill
G4WJS.

------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
wsjt-devel mailing list
wsjt-devel@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/wsjt-devel

Reply via email to