Scott, Please read Joe's note below:
> Depending on what code revision you upgrade from, it may be necessary to do a > one-time reset of the default list of suggested operating frequencies. Go to > *File->Settings->Frequencies*, right click on the table and select *Reset*. 73, Ulde IK2TYL > On 2 Sep 2017, at 16:37, Scott Bidstrup <[email protected]> wrote: > > Gentlemen, > > I have downloaded and installed the RC2 release software, and am delighted to > report that, for the most part, it is working. > > One problem I have noted, though, is that the drop-down frequency list, in > all modes, seems to be missing in the new version (downloaded from > sourceforge) - it's stuck on the last frequency I used in the old version, > and can't be changed so far as I know. Mark and replace does not work, and > there's nothing at all in the drop-down list in any mode to select from. > > Since I can't change the frequency, this is a serious problem for logging and > reporting. Is there a quick and easy fix for this? Please don't tell me I'm > going to have to manually enter ALL the frequencies for ALL the modes... Not > sure I have that much patience. > > Scott Bidstrup > TI3/W7RI > > ------------------------------------------------------------------------------ > Check out the vibrant tech community on one of the world's most > engaging tech sites, Slashdot.org! http://sdm.link/slashdot > _______________________________________________ > wsjt-devel mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/wsjt-devel ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ wsjt-devel mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/wsjt-devel
