On 21/09/2017 19:48, Bill Turner via wsjt-devel wrote:
I was operating r8094 on 17m, 18.100.000. I then compiled r8101 and
clicked on the shortcut to bring it up. The frequency showed as 18
100 055. Clicking on the frequency box to get back to the 17m
default, the box and the radio now show 18 100 000. I have seen this
on previous builds also. Icom IC-7300, Win10, usb cable interface.
Hi Bill.
WSJT-X goes through a short series of steps to determine the rig's
frequency resolution when it first connects to the rig. For most rigs,
i.e. those with one Hertz or ten Hertz resolution, this consists of
reading the current frequency, QSYing to the current kHz rounded down
plus 55 Hz, then QSYing back to where the rig was when the connection
was opened. The net result should be no change in frequency.
If your rig is being left at X plus 55 Hz and was not at that frequency
before starting WSJT-X then something is not working correctly with your
CAT interface.
What do you have the "Settings->Radio->Poll interval" option set to?
73
Bill
G4WJS.
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
wsjt-devel mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
