On 12/05/2018 20:47, [email protected] wrote:
Is it possible to not have to use split mode with a SDR like an Anan
or a Flex-6000 series? The audio chain on my Flex-6700 is all digital,
and I can set my receive bandwidth as high as 12kHz and the transmit
as high as 10kHz on SSB digital (DIGU/DIGL). I wouldn't need to use
"Fake it" or split.
73
Ria, N2RJ
Hi Ria,
you will get a warning at startup in Hound mode or when switching to
Hound mode, dismiss that and you can carry on without using SPLIT on
your rig nor "fake It" mode. I would check with a local station
transmitting by down near 300Hz and have them make sure nothing unwanted
is happening across their Rx bandwidth.
For others; this advice is only for those using an all digital audio
chain, with analogue audio which includes many of the rigs that have
build in USB audio because they convert to analogue before feeding the
modulator, using "Settings->Radio->Split Operating" as "Rig" or "Fake
It" is almost essential if you intend to set your Tx audio offset below
1500 Hz.
73
Bill
G4WJS.
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
wsjt-devel mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
