On 29/06/2018 11:46, Lorenzo IZ0KBA via wsjt-devel wrote:
Hello,
I'm Lorenzo IZ0KBA.
Can WSJT-x accept command input by UDP?
I need to write the callsing in the DX CALL textbox. It's possible this?
Thanks
Hi Lorenzo,
the UDP message protocol used by WSJT-X is documented here:
https://sourceforge.net/p/wsjt/wsjtx/ci/master/tree/NetworkMessage.hpp
the interaction you are requesting is not allowed because it can be used
to automate QSOs which is something WSJT-X is not designed to do.
What you can do is initiate a QSO by replying to a CQ decode, or you can
set up WSJT-X ready to make a QSO by using the same Reply (type 4)
message to a non CQ or QRZ decoded message. The start of a QSO set up
the latter way must be done by the operator using the WSJT-X UI
controls, any attempt to automate this using another application or tool
will be seen as a misuse of WSJT-X and the UDP message facility will
probably be severely restricted or even removed if evidence of that is
discovered.
73
Bill
G4WJS.
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
wsjt-devel mailing list
wsjt-devel@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
