Yes I am jumping between 1 and 2 as I do not understand any other way.
I start CQ with label 1 Tx6.
As the TX6 is not given the locator I go also to free text to give as
stations are asking it.
But I think that the problem was in Windpws update..
73 Keijo OG55W
-----Alkuperäinen viesti-----
From: Joe Taylor
Sent: Monday, October 1, 2018 5:50 PM
To: WSJT software development
Subject: Re: [wsjt-devel] Free text problem
Keijo,
On 10/1/2018 10:31 AM, OG55W wrote:
1. Start WSJT-X 2.0-rc2 with "MyCall" = OG55W
2. CQ OG55W in Tx6
3. Select a free text message in Tx6 "RC2 PSE"
4. After transmission finishes, select General message
5.QSY to label 1 Std Messages
6. Try to CQ again, but do not get Enable TX red.
7. Close the WSJT-X
8. Open WSJT-X and everything is working again.
I assume your step 2 means that you allow the program to transmit a CQ
message using message field Tx6 on Tab 1.
Your step 3 says "select a free text message in Tx6". The only TX#
message field that allows "selecting" a pre-stored message is Tx 5. So
I don't know what you did here. Did you menually enter "RC2 PSE" in
Tx6? Or select a pre-stored "RC2 PSE" inn Tx5? Or something else?
Your step 4 says "select General message". This appears to be a
reference to the "Gen msg" entry field of Tab 2? Are you really
changing between Tab 1 and Tab 2? If so, why? Users are assumed to use
either Tab 1 or Tab 2, but not both in the same QSO.
When you write "QSY to label 1 Std Messages", do you mean that you
selected Tab 1 and then clicked "Generate Std Msgs" ??
I am baffled. I can't make the program do what you say it does for you.
-- Joe, K1JT
_______________________________________________
wsjt-devel mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
_______________________________________________
wsjt-devel mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
