Hi Bill,All understood. I could not reproduce the "failure". I did not change
the Rx audio offset nor the settings of this morning and nevertheless the
message did not show up.Sorry for the false report/alert.If possible, the only
change to do in this case is to correct the typo in the message: from sybmode
to submode.:-)Thanks and 73
Alex, XE1MEX
On Friday, October 12, 2018, 5:31:37 PM CDT, Bill Somerville
<g4...@classdesign.com> wrote:
On 12/10/2018 22:55, Alex Diaz - XE1MEX via wsjt-devel wrote:
> Hi all,
> I was trying to receive data from the DSLWP-B Lunar Satellite on 435.4
> MHz and 436.4 MHz in mode JT4G but I got the message *** Rx Freq is
> set too high for this sybmode ***.
>
Hi Alex,
it is not the RF frequency that is too high, it is the highest audio
tone of the demodulated signal that is too high. The highest tone must
be below 2756.25 Hz and you have the lowest tone at 1776 ±200 Hz which
would make the highest tone in range 4181 Hz (1776 + 200 + 7 * 315). Try
setting your Rx audio offset to 100 Hz and retune the signal.
73
Bill
G4WJS.
_______________________________________________
wsjt-devel mailing list
wsjt-devel@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
_______________________________________________
wsjt-devel mailing list
wsjt-devel@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
