Joe and team,
One issue I also just encountered - while working you Joe actually - was that I had only spun the dial onto 7080 I hadn't programmed it into the frequency list. When I started calling CQ it was fine and I worked my first station with "hold TX Freq" checked plus Call First and AutoSeq checked. At the end of the first caller cycle I didn't immediately select enable TX to have another round, however Joe called me while I was trying to sort out the logging again - so I double clicked on his call in the Band Activity window and then wondered why he disappeared. After about 90 seconds I glanced over at my SDR and realised my signal was in the lower cluster of signals - looked at the rig and realised it had jumped back to 7074. I can already see there are two blocks of contesters on 40m and so manually tuning the dial I can see will become more common. It would be good if the system could be put in a mode where VFO-A (receiver control) can always be taken from the rig and VFO-B (in split mode) is managed as an offset from VFO A only. It would be a return to more of the PSK contesting days where you still tuned the dial to work everyone in your 2-3kHz RX window - then move on to the next cluster. Regards, Grant VK5GR
_______________________________________________ wsjt-devel mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/wsjt-devel
