On 03/12/2018 13:03, Brian Waterworth wrote:
I had the same issue as you describe and recalled that I had not
selected the "Allow TX Frequency changes while transmitting" setting
on the Settings...General tab. Checking this setting solved the first
problem highlighted in this thread.
Hi Brian,
thanks for that report. That setting is essential for certain rigs that
will not accept some CAT command while transmitting. Notably, but not
restricted to, the Yaesu FT-817/857/897(D) series. There are edge cases,
that are out of our control, around the transition time between Rx and
Tx and vice versa that could mean a CAT command does not get passed to
the rig when this option is checked. SignaLink USB users for example
should set the delay knob to minimum if possible.
The option should be checked if possible, but only if you are sure your
rig can accept CAT QSY commands while transmitting.
73
Bill
G4WJS.
_______________________________________________
wsjt-devel mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
