I believe this is intentional and is mentioned in point 11 under the "detailed instructions for hounds" in this document: https://physics.princeton.edu/pulsar/k1jt/FT8_DXpedition_Mode.pdf
73 de Tom OH6VDA > 8. okt. 2019 kl. 08:45 skrev K2DBK-WSJT <[email protected]>: > > > I’ve noticed that in F/H mode after I call 5 times Enable Tx will turn off, > similar to what happens in non F/H mode when the Tx watchdog expires. > However, unlike in that case, there’s no red indicator in the lower left > corner, it just stops sending. I’ve confirmed that my watchdog timer is set > higher than that (just in case) and it’s set to 6 minutes. The number of > cycles seems to be consistent, and I’ve got no issue in other modes, ruling > out something like RF causing an issue. I’ve looked through the documentation > and couldn’t find any reference to maximum number of calls before it will > stop on its own. I’m not transmitting on top of the Fox, I’ve seen this both > with and without “Rx All Freqs” set. One thing I’ve noticed is that just > before Enable Tx turns off, the Decode button will flicker very briefly, > something I don’t see at any other time. Also, even though it seems to be on > the 5th transmit cycle, it looks like sometimes the Enable Tx button will > turn off just as a transmission is starting, and sometimes immediately after > it’s finished. I’m baffled. > > I’m running v2.1.0 on Windows 10 1903 build 18362. I’ve got Save All checked > in case those files would be of any use in diagnosing this. > > 73, > David, K2DBK > _______________________________________________ > wsjt-devel mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/wsjt-devel
_______________________________________________ wsjt-devel mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/wsjt-devel
