Hello, I am observing some split operation issues with WSJT-X 2.2.0-rc2 on macOS and IC-7300.
My Setup: Computer: macOS Catalina 12.15.4 Rig: Icom IC-7300 WSJT-X 2.2.0-rc2 WSJT-X Radio Tab: Rig: Icom IC-7300 Serial Port: /dev/cu.SLAB_USBtoUART Baud Rate: 115200 Data Bits: Eight Stop Bits: One Handshake: None PTT Method: CAT Mode: Data/Pkt Split Operation: Rig Test CAT is green Steps: 1. Split is off on Rig 2. WSJT-X is set to 20m band (140.074.000 MHz) 3. Rig dial frequency is 14.074.00 MHz 4. WSJT-X Tx offset is 1500 Hz 5. Press Tune 6. Rig changes to split mode and transmits on 14.074.00 MHz 7. Change WSJT-X Tx offset to 500 Hz 8. Press Tune 9. Rig transmits on 14.074.00 MHz (expected 14.073.00 MHz) 10. Change WSJT-X Tx offset to 2500 Hz 11. Press Tune 12. Rig transmits on 14.074.00 MHz (expected 14.075.00 MHz) 13. Turn off split on rig and leave WSJT-X Tx offset at 2500 Hz 14. Press Tune 15. Rig transmits on 14.075.00 MHz 16. Change WSJT-X Tx offset to 1500 Hz 17. Press Tune 18. Rig transmits on 14.075.00 MHz (expected 14.074.00 MHz) 19. Change WSJT-X Tx offset to 500 Hz 20. Press Tune 21. Rig transmits on 14.075.00 MHz (expected 14.073.00 MHz) 22. At this point I notice that when transmission stops, the rig dial frequency quickly changes from 14.075.00 to 14.073.00 and then to 14.074.00. It appears that the the split offset is correctly applied when split is off on the rig, but the offset doesn't change thereafter. No problems are observed when running these same steps with WSJT-X 2.1.2. 73, Matt, NR3M _______________________________________________ wsjt-devel mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/wsjt-devel
