Thanks Peter, I failed to mention, that was confirmed. Thanks for the
response.
Don/N7BD
On 6/15/2020 7:00 PM, Peter Sumner wrote:
Hello Don,
as this is a new install of Windows 10, you may find the inbuilt
Windows 10 security is preventing WSTJ-X from accessing a 'microphone
device'. Please go to Windows 10 start menu / Settings / Privacy and
then Microphone and ensure the slider to allow all apps to access your
microphone device is enabled.
Hope this helps.
regards,
Peter, vk5pj
On Tue, Jun 16, 2020 at 5:09 AM DonMcMahon <[email protected]
<mailto:[email protected]>> wrote:
I am getting an “Error on Sound Input” message when I start WSJT-X
and have not been able to resolve it. It occurs immediately when I
start WSJT-X v2.2.1 but, through troubleshooting, I noticed it is
also occurring on earlier versions. It is not related to RFI since
this occurs immediately after a program start well prior to any
transmissions.
I had just built a new Windows 10, 64-bit based machine with 64 GB
memory and migrated my old hard drive to new M2 drives. My former
machine had Windows version 1904 and after it was migrated to the
new hardware, it was upgraded to Windows 2004 on the new hardware.
All other programs appear to be working correctly except with the
error message with loading WSJT-X.
I am using an ICOM IC-7610 radio with built-in sound interface and
I have verified its radio menu settings with a friend’s radio. The
new computer has the ICOM driver installed, Silicon Labs USB to
UART Bridge Drivers, version 1.30.
These are the steps I have taken so far.
1.Re-installed ICOM USB drivers,
2.Rolled back WSJT-X to v2.0.0 with same results and then
reinstalled v2.2.1,
3.Confirmed no other programs are using the Silicon Labs USB to
UART Bridge drivers,
4.Confirmed microphone privacy settings are set to allow device,
5.Confirmed IC-7610 set to Default Communications Device, and
6.I did find that WJT-X can be set to another microphone input it
will begin functioning; that leads me to believe it is a ICOM
radio sound card problem.
Has anyone come across this issue with “Error in Sound Input” and
found how to resolve it with the ICOM IC-7610? Any trouble
shooting ideas will be helpful.
Don, N7BD
_______________________________________________
wsjt-devel mailing list
[email protected]
<mailto:[email protected]>
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
_______________________________________________
wsjt-devel mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
_______________________________________________
wsjt-devel mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
